Function Setting - Vane Angle Control; Function Setting - Change Temp - LG PQRCVSL0 Owners & Installation Manual
New wide wired remote controller for air conditioner
Hide thumbs
Also See for PQRCVSL0:
- Owners & installation manual (34 pages) ,
- Installation manual (23 pages) ,
- Owner's manual (239 pages)
Table of Contents
Advertisement
Owner's Instructions
Function setting - Vane Angle Control
This function is to adjust angle at which airflow is blown out.
46 New Wide Wired Remote Controller
Press the
button until the
1
icons flashes.
Press
button to select active vane :
2
1 / 2 / 3 / 4 / All / Standard
Select Vane number using
buttons.
❈ Vane number : No. 1, 2., 3, 4, all, or
standard
- Selected vane is in operation.
- Please verify the operating vane.
- To set the angle of all the vanes,
select 'all'.
- To set as the factory default settings,
select 'standard'.
3
Select wind angle using
button, and
press
button.
- The boundary of wind angle settings can
be changed to 5 levels or 6 levels
according to the product.
- When selecting 'standard' for Vane
number, the wind angle does not move.
Set the angles for the remaining vanes
4
by following the same steps.
Pressing the
button will exit
5
the settings mode. If
is not
pressed, the remote controller
will automatically exit setup mode after
25 seconds with no input. If the set button
is not pressed, the changes will not take
effect.
Press
button to complete and
6
activate the setting process.
(Airflow direction function will be
released whenever setting vane angle)
7
Press
button to exit or
system will automatically release
without any input after 25
seconds.
Function Setting - Change Temp
Change temperature function can change a delta temperature of Auto change over function. The
change temperature value consist certain gap between cooling and heating change over points.
Owner's Instructions
1
Press the
button until the
icons flashes.
2
Press
button to change.
❈ Converting temp value : 1~7
3
Press
button to complete
and active the setting process.
Pressing the
button will exit
4
the settings mode. If
is not
pressed, the remote controller
will automatically exit setup mode
after 25 seconds with no input.
If the set button is not pressed,
the changes will not take effect.
Owner's & Installation Manual 47
Hide quick links:
Advertisement
Table of Contents
