Installer Setting - Zone Number Setting; Installer Setting - Emergency Heater Setting - LG PQRCVSL0 Owners & Installation Manual
New wide wired remote controller for air conditioner
Hide thumbs
Also See for PQRCVSL0:
- Owners & installation manual (34 pages) ,
- Installation manual (23 pages) ,
- Owner's manual (239 pages)
Table of Contents
Advertisement
Installation Instructions
Installer Setting - Zone Number Setting
This function is only available on some products.
Zone Number is to set the number of installed zones. It is possible to control only in zone new type
24 New Wide Wired Remote Controller
1
Pressing and holding the
button for
3 seconds enters the remote
controller setup mode. If it is
not held for 3 seconds, it enters
the user setup mode.
2
Press
repeatedly until it shows
Function code 14.
Function Code
Zone Number installed
Ex) Setting the Zone Number for "2"
Select Zone Number by pressing
3
button
(02~04 : number of zone installed)
4
Press
button to save or release.
5
Pressing the
button will exit
the settings mode. If
is not
pressed, the remote controller will
automatically exit setup mode after 25
seconds with no input. If the set button is
not pressed, the changes will not take
effect.
Installer Setting - Emergency Heater Setting
This function is only available on some products
This function will set the Emergency Heater Setting.
Emergency Heater is used to heat the space in emergency case such as heat pump error.
Emergency heat is in place of and does not supplement heat pump.
※ Emergency Heater setting Function sets following conditions:
1) Emergency Heater operation while in error or outdoor unit operates cooling cycle.
2) Emergency Heater operation in Low Ambient temperature
3) Fan speed setting during Emergency Heater operation
CAUTION
This function setting must be carried out by a certified-technician.
Incorrect function setting can cause fire.
Setting1 : Heater
Operation while in error
Setting2 : Low Ambient
or outdoor unit operates
Heating Operation
cooling cycle.
Setting3 : FAN Speed
Setting during Emergency
Heater Operation
Installation Instructions
Pressing and holding the
button for
1
3 seconds enters the remote
controller setup mode. If it is
not held for 3 seconds, it enters
the user setup mode.
2
Press
repeatedly until it shows
Function code 18.
Function Code
Setting1: Heater Operation while in error or
outdoor unit operates cooling cycle.
Select mode of Heater Operation while
3
in error by pressing
button
00: not use
01: use
If 00 is set at this stage, setting 2 and
setting 3 will not be available
Owner's & Installation Manual 25
Hide quick links:
Advertisement
Table of Contents
