Installer Setting - Celsius / Fahrenheit Switching; Installer Setting - Zone Type Setting - LG PQRCVSL0 Owners & Installation Manual
New wide wired remote controller for air conditioner
Hide thumbs
Also See for PQRCVSL0:
- Owners & installation manual (34 pages) ,
- Installation manual (23 pages) ,
- Owner's manual (239 pages)
Table of Contents
Advertisement
Installation Instructions
Installer Setting - Celsius / Fahrenheit Switching
This function is used for switching the display between Celsius and Fahrenheit.
C
Whenever press
button in Fahrenheit mode, the temperature will increase/drop 2
degrees.
22 New Wide Wired Remote Controller
Pressing and holding the
button for
1
3 seconds enters the remote
controller setup mode. If it is
not held for 3 seconds, it enters
the user setup mode.
2
Press
repeatedly until it shows
Function code 12.
Function Code
conversion mode value
Select Temperature unit mode by
3
pressing
button.
(00: Celsius, 01: Fahrenheit)
4
Press
button to save or release.
5
Pressing the
button will exit
the settings mode. If
is not
pressed, the remote controller will
automatically exit setup mode after 25
seconds with no input. If the set button is
not pressed, the changes will not take
effect.
Installer Setting - Zone Type Setting
This function is only available on some products.
It is possible to set up a new zone or select an old one to install the damper controller.
CAUTION
If you set zone number incorrectly, the product may malfunction especially in zone control.
This function must carried out by a certificated-technician.
Installation Instructions
Pressing and holding the
button for
1
3 seconds enters the remote
controller setup mode. If it is
not held for 3 seconds, it enters
the user setup mode.
2
Repeat pressing
button to select
Function code 13.
Function Code
Zone type value
Ex) Setting the Zone Type as "New"
3
Select Zone Type by pressing
button
(00:Old, 01:New)
4
Press
button to save or release.
Pressing the
button will exit
5
the settings mode. If
is not
pressed, the remote controller will
automatically exit setup mode after 25
seconds with no input. If the set button is
not pressed, the changes will not take
effect.
Owner's & Installation Manual 23
Hide quick links:
Advertisement
Table of Contents
