Installer Setting -Thermistor - LG PQRCVSL0 Owners & Installation Manual
New wide wired remote controller
Hide thumbs
Also See for PQRCVSL0:
- Owners & installation manual (38 pages) ,
- Installation manual (23 pages) ,
- Owner's manual (239 pages)
Table of Contents
Advertisement
Installation instruction
Function code,
ESP code
ESP value
•
Please be careful not to change the ESP value for each fan step.
•
It does not work to setup ESP value for very low/power step for some products.
•
ESP value is available for specific range belongs to the product.
14 New Wide Wired Remote Controller
6
Select ESP fan step again by using
button and setup ESP value, as No. 4
and 5, that corresponds each wind flow
7
Press
button to save.
8
Press
button to exit.
❈ After setup, it automatically gets out of
setup mode if there is no button input
for 25 seconds.
❈ When exiting without pressing set
button, the manipulated value is not
reflected.
Installer Setting -Thermistor
This is the function to select the temperature sensor to judge the room temperature.
<Thermistor Table>
Temperature sensor selection
01
Remote controller
Operation in remote controller temperature sensor
02
Indoor unit
Operation in indoor unit temperature sensor
Operation of higher temperature by comparing indoor unit's and wired
Cooling
remote controllerʼs temperature.
03
2TH
(There are products that operate at a lower temperature.)
Operation of lower temperature by comparing indoor unit's and wired remote
Heating
controller's temperature.
❊
The function of 2TH has different operation characteristics according to the product.
Installation instruction
1
If pressing
button long for 3
seconds, it enters into remote
controller setter setup mode.
- If pressing once shortly, it enters
into user setup mode. Please press
more than 3 seconds for sure.
2
If moving to room temperature perception
sensor selection menu by pressing
button, it indicates as picture below.
3
Set Thermistor value by pressing
button. (01: Remote Controller,
02: Indoor, 03: 2TH)
Function Code
Thermistor setting
4
Press
button to save.
Pressing
button will exit settings mode.
5
❈ After setup, it automatically gets out of
setup mode if there is no button input for
25 seconds.
❈ When exiting without pressing set button,
the manipulated value is not reflected.
Function
Ownerʼs & Installation Manual 15
- Quick Links:
- Standard Operation - Standard Cooling
Hide quick links:
Advertisement
Table of Contents
