Table of Contents
Advertisement
Controlling the LCD monitor via LCO Control
Connecting to a Oetwork
Using a LAN cable allows you to specify the Network Settings and the Alert Mail Settings by using an HTTP server function.
To use a LAN connection, you are required to assign an IP address. The monitor will obtain an IP address automatically when
connected to a DHCP network.
Example of LCO connectionN:
Oetwork Setting by Using an HUUP Browser
Iverview
Connecting the monitor to a network allows for remote control of the monitor from a computer connected to the network.
The IP address and subnet mask of the monitor can be set on the NETWORK SETTINGS screen of the web browser by using
an HTTP server. Please be sure to use "Microsoft Internet Explorer 10" or a higher version for the web browser.
(This device uses "JavaScript" and "Cookies" and the browser should be set to accept these functions. The setting method will
vary depending on the version of the browser. Please refer to the help files and the other information provided in your software.)
To access the HTTP server, launch a web browser on a computer connected to the same network as the monitor and enter the
following URL in the web address field.
Oetwork Setting
http://<the Monitor's IP address>/index.html
HIOUN:
The default IP address is assigned automatically to the monitor.
The exclusive application can be downloaded from our website.
OIUEN:
If the NETWORK SETTINGS screen does not appear in the web browser, press the Ctrl+F5 keys to refresh your web
browser (or clear the cache).
If the monitor appears to be slow in response to commands or clicks on buttons in the browser, or the general speed
of operation is unacceptable, this may be due to network traffic or the settings on your network. Should this happen,
consult your network administrator.
The monitor may not respond if the buttons shown on the browser are repeatedly pressed in rapid intervals. Should
this happen, wait a moment and repeat. If you still can't get a response, turn the monitor off and then back on.
To control a monitor please use the control command. See "Control command"
Server
NOTE: Use a category 5 or higher LAN cable.
Hub
LAN cable
(not supplied)
English-51
(page
57).
Advertisement
Table of Contents
