Table of Contents
Advertisement
Setup
1. Determine the installation location
CCUUIIO
•
Installing your monitor must be done by a qualified
technician. Contact your supplier for more information.
•
MOVING OR INSTALLING THE MONITOR MUST BE
DONE BY FOUR OR MORE PEOPLE. Failure to follow
this caution may result in injury if the LCD monitor falls.
•
Do not mount or operate the monitor upside down.
OIUEN:
This monitor has internal temperature sensors and
cooling fans, including a fan for the Option Board.
If the monitor becomes too hot, the cooling fans
will turn on automatically.
The Option Board's fan is active although the
temperature is lower than normal operating
temperature for cooling the Option Board. If the
monitor becomes overheated while the cooling
fan is running, a "Caution" warning appears. If the
"Caution" warning appears, stop using the unit,
turn off the power and allow it to cool. Using the
cooling fans will reduce the likelihood of early unit
failure and may help reduce image degradation
and "Image Persistance".
CCUUIION: If the monitor is used in an enclosed area or
if the LCD panel is covered with a protective
screen, please check the inside temperature
of the monitor by using the "HEAT STATUS"
control in the OSD (see
temperature is higher than the normal
operating temperature, please turn the
cooling fan to ON within the FAN CONTROL
menu within the OSD (see
IMPIRUCOUN: To avoid scratching the LCD panel, always
place a soft cloth, such as a blanket that is
larger than the monitor's screen area, on the
table before laying the monitor face down.
2. Install the remote control batteries
The remote control is powered by two 1.5V AAA batteries.
To install or replace batteries:
A. Press and slide to open the cover.
B. Align the batteries according to the (+) and (–) indications
inside the case.
C. Replace the cover.
CCUUIION: Incorrect usage of batteries can result in
leaks or bursting.
NEC recommends the following battery use:
•
•
•
•
•
OIUEN:
3. Connect external equipment
•
•
OIUEN:
4. Connect the supplied power cord
•
page
41). If the
•
page
41).
•
OIUEN:
English-15
Place "AAA" size batteries matching the (+) and (-) signs
on each battery to the (+) and (-) signs of the battery
compartment.
Do not mix battery brands.
Do not combine new and old batteries. This can shorten
battery life or cause liquid leakage of batteries.
Remove dead batteries immediately to prevent battery
acid from leaking into the battery compartment.
Do not touch exposed battery acid, it may injure your skin.
If you do not intend to use the Remote Control for
a long period of time, remove the batteries.
(See
page
17,
page 18
To protect the external equipment, turn off the main power
before making connections.
Refer to the user's manual of your equipment for further
information.
Do not connect/disconnect cables when turning
on the monitor or other external equipment, as this
may result in a loss of the monitor image.
The monitor should be installed close to an easily
accessible power outlet.
Fasten the power cord to the monitor by attaching the
screw and clamp. (Recommended Fasten Force:
139 - 189N•cm).
Fully insert the prongs into the power outlet socket.
A loose connection may cause image instability and may
pose a fire hazard.
Please refer to the
"Important Information"
of this user's manual for proper selection of an AC
power cord.
Screw
Clamp
and
page
19)
section
Advertisement
Table of Contents
