Table of Contents
Advertisement
Power Indicator
LED indicator
status and
Condition
lighting pattern
Glowing blue
Normal
Blinking green*
Under any of the conditions
1
below, no input signal has been
detected by the monitor during
the period of time you set:
• The monitor is using an
Option Board.
• INPUT DETECT is set to a
setting except for NONE.
• USB POWER is set to ON.
• DisplayPort in the TERMINAL
SETTINGS is set to MST.
Glowing amber
No AV signal input has been
detected by the monitor during
the period of time you set.
(with network signal input)
Blinking amber
No AV signal input has been
detected by the monitor during
the period of time you set.
(no network signal input)
Glowing red
Turn off the monitor by the
remote control or the monitor
button.
*1: Time setting for AUTO POWER SAVE is available at POWER SAVE
(See
page
41).
OIUEN:
If the indicator is blinking red in a combination
of long and short, a certain failure might have
occurred, please contact your supplier.
Using Power Management
This monitor follows the VESA approved DPM (Display
Power Management) function.
The power management function is an energy saving
function that automatically reduces the power consumption
of the monitor when the keyboard or the mouse has not been
used for a fixed period.
This allows your monitor to enter a Power Management
mode if the monitor's POWER SAVE function is set to
ENABLE, and a certain amount of time has passed since the
monitor recognized "no signal input". It will increase the life
and decrease the power consumption of the monitor.
OIUEN:
Depending on the computer and display card
used, this function may not operate.
After the video signal was lost, the monitor
automatically goes into OFF at a preset time
period.
Cspect
For MP (Media Player)
Recovery
FULL
For DisplayPort1, DisplayPort2, OPTION*
FULL
For HDMI1, HDMI2, HDMI3
FULL
1. Turn on the monitor
by the remote
control or the
*1: This function depends on which Option Board you are using.
monitor button.
2. Send an AV signal
Aspect ratio
input to the monitor.
of image
4:3
Turn on the monitor by
the remote control or
the monitor button.
Squeeze
Letterbox
OIRMCLN: Reproduces the aspect ratio that is sent from the
source.
FULLN: Fills the entire screen.
WIDEN: Expands a 16:9 letterbox signal to fill the entire
screen.
DYOCMICN: Expands a 4:3 pictures to fill the entire screen
with non-linearity. Some of the outside image area will be cut
off due to expansion.
1N:1N: Shows the image in a 1 by 1 pixel format.
ZIIM
The image can be expanded beyond the active screen area.
The parts of the image outside the active screen area are not
shown.
English-21
ZOOM
NORMAL
1:1
ZOOM
NORMAL
WIDE
DYNAMIC
1:1
Recommended selection
Unchanged view*
3
NORMAL
DYNAMIC
FULL
WIDE
*
3
Grey areas indicate unused portions of the screen.
ZOOM
1
ZOOM
NORMAL
for picture aspect*
3
ZOOM
Advertisement
Table of Contents
