Video Out Connection - NEC MultiSync UN552 User Manual
Large format display
Hide thumbs
Also See for MultiSync UN552:
- User manual (129 pages) ,
- Firmware update procedure (13 pages) ,
- Installation manual (5 pages)
Table of Contents
Advertisement
•
Video daisy chaining.
We strongly recommend using the same monitor model for all monitors in the connected daisy-chain.
MONITORS POSITION is different from ID. Please refer to the figure1.
Video Out Connection
Main picture
DisplayPort1
DisplayPort1
Connector
(DAISY
CHAIN IN)
DisplayPort
Yes
HDMI
No
NOTEN:
The output of Media Player signal (MP) is capable only between the same models.
For connecting multiple monitors with HDMI cable
•
Using the same display model.
•
Set the same ([MODE1] or [MODE2]) at [HDMI] in [TERMINAL SETTINGS] in all connected multiple monitors.
For DisplayPort Out
•
Select either the DisplayPort1 or OPTION input for the monitor to output a signal from DisplayPort Out.
•
This monitor's signal output function supports contents protected by HDCP. HDCP content can be distributed across up
to 3 connected monitors.
•
When using an Option Board, please set [SLOT2 CH SETTING] to [CH1] then set [SLOT2 CH SELECT] to DisplayPort.
See
page
122.
NOTEN:
Please use slot2 type option boards which outputs DisplayPort signal.
For HDMI Out
•
Select either the HDMI1, DVI, MP, or OPTION input for the monitor to output a signal from HDMI OUT.
•
This monitor's signal output function supports contents protected by HDCP.
HDCP content can be distributed across multiple connected monitors as described below:
•
HDCP 1: Up to 8 monitors / HDCP 2.2: Up to 5 monitors.
•
The time until image is displayed depends on the number of connected monitors.
•
Without HDCP: Up to 9 monitors.
NOTEN:
•
Depending on the device you use, number of monitor connection will change.
•
When displaying an image in a multi-monitor setting, do not disconnect cables from the monitors. When you
disconnect cables, please turn the main power off first.
•
When using an option, please set [SLOT2 CH SETTING] to [CH1] then set [SLOT2 CH SELECT] to TMDS. See
NOTEN:
Please use slot2 type option boards which outputs HDMI signal.
ID:1
ID:2
1
2
ID:6
ID:5
4
5
ID:7
ID:8
7
8
DisplayPort2
DVI
HDMI1
HDMI1
DisplayPort2
DVI-D
(DAISY
CHAIN IN)
No
No
No
No
Yes
Yes
ID:3
3
H MONITORS: 3
ID:4
6
V MONITORS: 3
POSITION: 4, 5, 6
ID:9
9
Figure 1
VGA
VGA
HDMI2
(RGB)
(YPbPr)
HDMI2
VGA (RGB, YPbPr)
(CEC)
No
No
No
No
No
No
English−72
Video
OPTION
Option Board
Option Board
VIDEO
Slot (SLOT2
Slot (SLOT2
(DP))
(HDMI))
No
Yes
No
No
MP
-
No
No
Yes
Yes
page
122.
Advertisement
Table of Contents
