Setup Overview - NEC MultiSync UN552 User Manual
Large format display
Hide thumbs
Also See for MultiSync UN552:
- User manual (129 pages) ,
- Firmware update procedure (13 pages) ,
- Installation manual (5 pages)
Table of Contents
Advertisement
Setup Overview
1. Determine the installation location
CAUTIONN:
• Installing your monitor must be done by a qualified technician.
Contact your supplier for more information.
• MOVING OR INSTALLING THE MONITOR MUST BE DONE BY TWO OR MORE PEOPLE. Failure to
follow this caution may result in injury if the monitor falls.
• This monitor has internal temperature sensors and cooling fans, including a fan for the Option Board.
If the monitor becomes too hot, the cooling fans will turn on automatically.
The Option Board's fan is active although the temperature is lower than normal operating temperature
for cooling the Option Board. If the monitor overheats while the cooling fan is running, a "Caution"
warning appears. If the "Caution" warning appears, stop using the unit, turn off the power and allow it
to cool. Using the cooling fans will reduce the likelihood of early unit failure and may help reduce image
degradation and "Image Persistence".
If the monitor is used in an enclosed area or if the LCD panel is covered with a protective screen,
please check the inside temperature of the monitor by using the HEAT STATUS control in the OSD
(see
page
cooling fan to [ON] within the [FAN CONTROL] menu within the OSD (see
NOTEN:
To avoid scratching the LCD panel, always place a soft cloth, such as a blanket that is larger than the monitor's
screen area, on the table before laying the monitor face down.
2. Install the remote control (Optional) batteries
The remote control is powered by two 1.5 V AAA batteries.
To install or replace batteries:
1. Press and slide to open the cover.
2. Align the batteries according to the (+) and (–) indications inside the case.
3. Replace the cover.
NEC recommends the following battery use:
CAUTIONN:
Incorrect usage of batteries can result in leaks or bursting.
•
Place "AAA" size batteries matching the (+) and (-) signs on each battery to the (+) and (-) signs of the battery
compartment.
•
Do not mix battery brands.
•
Do not combine new and old batteries. This can shorten battery life or cause liquid leakage of batteries.
•
Remove dead batteries immediately to prevent battery acid from leaking into the battery compartment.
•
Do not touch exposed battery acid, it may injure your skin.
NOTEN:
If you do not intend to use the Remote Control for a long period of time, remove the batteries.
3. Connect external equipment (See page 23)
•
To protect the external equipment, turn off the main power before making connections.
•
Refer to the user's manual of your equipment for further information.
NOTEN:
Do not connect/disconnect cables when turning on the monitor or other external equipment as this may result in
loss of image.
116). If the temperature is higher than the normal operating temperature, please turn the
English−7
page
116).
Advertisement
Table of Contents
