Setting The Aspect Ratio - NEC MultiSync UN552 User Manual
Large format display
Hide thumbs
Also See for MultiSync UN552:
- User manual (129 pages) ,
- Firmware update procedure (13 pages) ,
- Installation manual (5 pages)
Table of Contents
Advertisement
Setting the Aspect Ratio
Press the ASPECT button on the remote control to cycle through the options available for the current input signal.
For MP (Media Player), VIDEO
➙
➙
•
FULL
ZOOM
NORMAL
For DVI, DisplayPort1, DisplayPort2, VGA (RGB), OPTION*
➙
➙
➙
•
FULL
1:1
ZOOM
*
: This function depends on which Option Board is installed in the monitor.
1
*
2
: This input is available when the optional Raspberry Pi Compute Module Interface Board and Raspberry Pi Compute Module are installed.
For VGA (YPbPr), HDMI1, HDMI2
➙
➙
•
FULL
WIDE
DYNAMIC
Aspect ratio of
Unchanged view*
image
4:3
Squeeze
Letterbox
*
2
: Gray areas indicate unused portions of the screen.
1:1: Shows the image in a 1 by 1 pixel format.
ZOOM
•
The zoom function increases the image size, which expands the image beyond the active screen area. The parts of the
image outside the active screen area are not shown.
NORMAL
➙
➙
➙
1:1
ZOOM
NORMAL
2
Recommended selection for picture
aspect*
[NORMAL]
[DYNAMIC]
[FULL]
[WIDE]
ZOOM
, COMPUTE MODULE*
1
2
2
Reproduces the aspect ratio that is sent from
the source.
Expands a 4:3 picture to fill the entire screen
with non-linearity. Some of the outside image
area will be cut off due to expansion.
Fills the entire screen.
Expands a 16:9 letter box signal to fill the entire
screen.
ZOOM
English−35
Description
Advertisement
Table of Contents
