Osd - NEC MultiSync UN552 User Manual
Large format display
Hide thumbs
Also See for MultiSync UN552:
- User manual (129 pages) ,
- Firmware update procedure (13 pages) ,
- Installation manual (5 pages)
Table of Contents
Advertisement
MULTI-INPUT MENU
DisplayPort
BIT RATE
HDMI
VIDEO LEVEL
SIGNAL FORMAT
HDMI1, HDMI2, DisplayPort1,
DisplayPort2, COMPUTE MODULE,
OPTION only
RESET
OSD
OSD MENU
LANGUAGE
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
ESPAÑOL
SVENSKA
РУССКИЙ
OSD TIME
OSD POSITION
UP
DOWN
RIGHT
LEFT
Selects the DisplayPort mode [1.1a] or [1.2].
DisplayPort 1.1a is selected, [SST] is set automatically.
DisplayPort 1.2 is selected, set [SST] or [MST*].
* DisplayPort 1.2 should be selected when using Multi-Stream Transport. Multi-Stream Transport requires a
corresponding display card. Contact your supplier for limitations of this function.
NOTE: MST is not available with DisplayPort2 signal input.
DisplayPort 1.1a is selected at DisplayPort, [HBR] is set automatically.
DisplayPort1.2 and SST are selected at DisplayPort, set [HBR] or [HBR2].
DisplayPort1.2 and MST are selected at DisplayPort, [HBR2] is set automatically.
Sets the HDMI mode.
MODE1: Max resolution is 3840 x 2160 (30 Hz).
MODE2: Max resolution is 3840 x 2160 (60 Hz), HDCP 2.2, or HDR.
Adjust the gradation range to be displayed according to the video signal to improve the whiteout and blackout
of the image.
RAW: For computer settings. Show all input signals of 0-255 gray levels.
EXPAND: For audio-visual equipment settings. Expands the input signals from 16-235 gray levels to
0-255 gray levels.
AUTO: Automatically sets input signals by adjusting connected equipment.
NOTE: This function is available only in [HDMI] or [DisplayPort] or [OPTION] and is selected at [INPUT
SIGNAL].
Selects the color space setting and RBG for the HDMI/DisplayPort signal.
NOTE: If [SLOT2 CH SETTING] is [CH2], this function is grayed out.
Resets MULTI INPUT options back to factory settings, except for [INPUT DETECT] (priority of input signals
only), [INPUT CHANGE] (INPUT1 and INPUT2), [INPUT SELECT], [PICTURE ASPECT] and [BIT RATE].
Select the language used by the OSD.
Turns off the OSD after a period of inactivity. The preset choices are 10-240 seconds.
Determines the location where the OSD appears on the screen.
English−111
Advertisement
Table of Contents
