NEC MultiSync UN552 User Manual page 117
Large format display
Hide thumbs
Also See for MultiSync UN552:
- User manual (129 pages) ,
- Firmware update procedure (13 pages) ,
- Installation manual (5 pages)
Table of Contents
Advertisement
MULTI-DSP MENU
SETTING COPY
COPY START
ALL INPUT
TILE MATRIX
H MONITORS
V MONITORS
POSITION
TILE COMP
TILE CUT
TILE MATRIX ENABLE
FRAME COMP
NONE
AUTO
MANUAL
Copies some of the OSD menu categories to the other monitors when they are chained together.
NOTE: When you use this function, monitors should be daisy chained by LAN cables. The selection of which
settings to copy will be reset to default when the monitor is powered off. The number of monitors that the
settings can be copied to may be reduced based on the quality of the LAN cables being used. Please see the
"Setting copy.pdf" file on the NEC website.
Highlight and press SET to select each setting that needs to be copied to the other monitors, or select
[ALL INPUT]. Highlight [YES] and press SET to start copying the settings.
When this option is selected, all input terminal settings are copied.
Allows one image to be expanded and displayed over multiple screens (up to 100) through a distribution
amplifier. This option is for manually configuring the TILE MATRIX settings that are automatically configured
when using [AUTO TILE MATRIX SETUP].
NOTE:
•
Low resolution is not suitable for tiling to a large number of monitors.
•
You can operate without a distribution amplifier at a lower number of screens. These functions
are not available when [TILE MATRIX] is active: [MULTI PICTURE MODE], [TEXT TICKER], and
[CLOSED CAPTION] in the OSD menu, and the STILL and POINT ZOOM remote control buttons.
•
The tile matrix automatically deactivates when enabling any of the following functions:
- Selecting an [IMAGE FLIP] option in the [ROTATION] menu (except for [NONE]).
- Activating [MOTION] in the [SCREEN SAVER] menu.
•
If [DYNAMIC] or [ZOOM] is the selected aspect setting, they function as [FULL] aspect when the
tile matrix is active. While the tile matrix is active, changing the aspect setting to [DYNAMIC] or
[ZOOM] or changing the zoom level, does not affect the picture. When the tile matrix deactivates,
any settings changed while the tile matrix was active are immediately applied.
•
[POINT ZOOM] function automatically deactivates when [TILE MATRIX] is activated. Please refer
to the [POINT ZOOM] function for more detail.
•
If Media Player contents are played while [TILE MATRIX] is active, the image play timing might
have a gap within monitors.
•
When input signal is HDMI signal with 3840 x 2160 (60 Hz), [TILE MATRIX] is not available.
Number of monitors arranged horizontally.
Number of monitors arranged vertically.
Select the section of the tiled image to display on the current monitor.
Adjusts the image to compensate for the gap between displays.
When activated, the displayed image size and position can be adjusted by pressing the + or - button on the
remote control.
Selects part of the displayed image and displays it on the full screen.
Adjust the frame size by [H MONITORS] and [V MONITORS], then choose a frame [POSITION].
The frame position can be adjusted by pressing the + or - button on the remote control.
Starts the Tile Matrix.
Adds a delay to the displayed video in order to reduce frame gaps between tiled rows when showing moving
images.
NOTE:
•
The image may be distorted when turning the power on or changing the settings.
•
If [FRAME COMP] is set to [AUTO] or [MANUAL], [V SCAN REVERSE] is not available.
Without Frame Comp
FRAME COMP is not used.
Sets display timing to vertical direction of all monitors automatically.
Sets display timing to individual monitor.
With Frame Comp
Frame gap
English−113
Delay x 1
Delay x 2
Advertisement
Table of Contents
