Controlling The Lcd Monitor Via Lan Control; Connecting To A Network; Network Setting By Using An Http Browser - NEC MultiSync V984Q User Manual
Large format display
Hide thumbs
Also See for MultiSync V984Q:
- Installation manual (13 pages) ,
- Setup manual (71 pages) ,
- User manual (80 pages)
Table of Contents
Advertisement
Controlling the LCD monitor via LAN Control
Connecting to a Network
Using a LAN cable allows you to specify the Network Settings and the Alert Mail Settings by using an HTTP server function.
To use a LAN connection you are required to assign an IP address.
Example of LAN connection:
Network Setting by Using an HTTP Browser
Overview
Connecting the monitor to a network allows for monitor control from a computer via the network.
The IP address and subnet mask of the monitor can be set on the Network Setting screen of the web browser by using an HTTP
server. Please be sure to use "Microsoft Internet Explorer 10" or a higher version for the web browser.
(This device uses "JavaScript" and "Cookies" and the browser should be set to accept these functions. The setting method will
vary depending on the version of the browser. Please refer to the help files and the other information provided in your software.)
Access is gained to the HTTP server function by starting the Web browser on the computer via the network connected to the
monitor and entering the following URL as described below:
Network Setting
http://<the Monitor's IP address>/index.html
HINT:
The default IP address is assigned automatically to the monitor.
The exclusive application can be downloaded from our website.
NOTE:
If the MONITOR NETWORK SETTINGS screen does not appear in the web browser, press the Ctrl+F5 keys to
refresh your web browser (or clear the cache).
If the monitor appears to be slow in response to commands or clicks on buttons in the browser, or the general speed
of operation is unacceptable, this may be due to network traffic or the settings on your network. Should this happen,
consult your network administrator.
The monitor may not respond if the buttons shown on the browser are repeatedly pressed in rapid intervals. Should
this happen, wait a moment and repeat. If you still can't get a response, turn the monitor off and then back on.
To control a monitor please use the control command. See "Control command diagram"
Server
NOTE: Use a category 5 or higher LAN cable.
Hub
LAN cable
(not supplied)
English-51
(page
57).
Advertisement
Table of Contents
