Table of Contents
Advertisement
Wrap the insulation material around the connecting
portion.
1. Overlap the connection pipe heat insulation and the
indoor unit pipe heat insulation material. Bind them
together with vinyl tape so that there may be no gap.
2. Wrap the area which accommodates the rear piping
housing section with vinyl tape.
3. Bundle the piping and drain hose together by wrap-
ping them with cloth tape over the range within which
they fit into the rear piping housing section.
Reroute the pipings and the drain hose across the
back of the chassis.
Set the pipings and the drain hose to the back of
the chassis with the tubing holder.
• Hook the edge of tubing holder to tap on chassis and
push the bottom of tubing holder to be engaged at the
bottom of chassis.
Indoor unit installation
1. Remove the spacer.
2. Ensure that the hooks are properly seated on the
installation plate by moving it left and right.
3. Press the lower left and right sides of the unit against
the installation plate until the hooks engage into their
slots(clicking sound).
Copyright ©2009 LG Electronics. Inc. All right reserved.
Only for training and service purposes
Connection
pipe
Vinyl tape
(wide)
Connecting cable
Drain hose
Piping for
passage through
piping hole
- 19 -
Installation
Plastic bands Insulation material
Indoor
unit piping
Wrap with vinyl tape
Pipe
Vinyl tape(narrow)
Pipe
Vinyl tape(narrow)
Wrap with
vinyl tape(wide)
Tubing holder
Connecting
cable
Drain hose
LGE Internal Use Only
- Quick Links:
- Self-Diagnosis Function
- Outdoor Unit
Hide quick links:
Advertisement
Table of Contents
