Installation Of Wired Remote Controller - LG MULTI V PQRCVSL0 Installation Manual
Floor standing, concealed floor standing
Hide thumbs
Also See for MULTI V PQRCVSL0:
- Owners & installation manual (38 pages) ,
- Owner's manual (239 pages) ,
- Installation manual (23 pages)
Table of Contents
Advertisement
Installation
Installation of Wired Remote Controller
1. Please fix tightly using provided screw after placing remote controller setup board on the
place where you like to setup.
- Please set it up not to bend because poor setup could take place if setup board bends.
Please set up remote controller board fit to the reclamation box if there is a reclamation box.
2. Can set up Wired remote controller cable into three directions.
- Setup direction: the surface of wall reclamation, upper, right
- If setting up remote controller cable into upper and right side, please set up after removing remote
controller cable guide groove.
h Remove guide groove with long nose.
① Reclamation to the surface of the wall
② Upper part guide groove
③ Right part guide groove
3. Please fix remote controller upper part into the
setup board attached to the surface of the wall,
as the picture below, and then, connect with
setup board by pressing lower part.
- Please connect not to make a gap at the remote
controller and setup boardʼs upper and lower, right
and left part.
When separating remote controller from setup
board, as the picture below, after inserting into
the lower separating hole using screw driver
and then, spinning clockwise, remote controller
is separated.
- There are two separating holes. Please individu-
ally separate one at a time.
- Please be careful not to damage the inside
components when separating.
14
Indoor Unit
2
3
1
<Wire guide grooves<
<Connecting order>
Wall
Side
<Separating order>
Wall
Side
2
3
Wall
Side
Wall
Side
Advertisement
Table of Contents
