SAFETY INSTRUCTIONS
4
• Use the correctly rated breaker or fuse. There is risk of fire or electric shock.
• Do not modify or extend the power cable. There is risk of fire or electric shock.
• Do not install, remove, or re-install the unit by yourself (customer). There is risk of fire, electric
shock, explosion, or injury.
• Be cautious when unpacking and installing the product. Sharp edges could cause injury. Be
especially careful of the case edges and the fins on the condenser and evaporator.
• For installation, always contact the dealer or an Authorized Service Center. There is risk of fire,
electric shock, explosion, or injury.
• Do not install the product on a defective installation stand. It may cause injury, accident, or damage
to the product.
• Be sure the installation area does not deteriorate with age. If the base collapses, the air conditioner
could fall with it, causing property damage, product failure, and personal injury.
• Do not let the air conditioner run for a long time when the humidity is very high and a door or a
window is left open. Moisture may condense and wet or damage furniture.
• The appliance shall be stored in a well-ventilated area where the room size corresponds to the room
area as specified for operation. (for R32)
• Ducts connected to an appliance shall not contain an ignition source. (for R32)
• The appliance shall be stored in a room without continuously operating ignition sources
(for example:open flames, an operating gas appliance or an operating electric heater.)
• Keep any required ventilation openings clear of obstruction.
• Installation work must be performed in accordance with the national wiring standards by authorized
personnel only
Operation
• Take care to ensure that power cable could not be pulled out or damaged during operation. There is
risk of fire or electric shock.
• Do not place anything on the power cable. There is risk of fire or electric shock.
• Do not plug or unplug the power supply plug during operation. There is risk of fire or electric shock.
• Do not touch(operate) the product with wet hands. There is risk of fire or electric shock.
• Do not place a heater or other appliances near the power cable.There is risk of fire and electric
shock.
• Do not allow water to run into electric parts. There is risk of fire, failure of the product, or electric
shock.
• Do not store or use flammable gas or combustibles near the product. There is risk of fire or failure of
product.
• Do not use the product in a tightly closed space for a long time. Oxygen deficiency could occur.
• When flammable gas leaks, turn off the gas and open a window for ventilation before turning the
product on. Do not use the telephone or turn switches on or off. There is risk of explosion or fire
• If strange sounds, or smell or smoke comes from product. Turn the breaker off or disconnect the
power supply cable. There is risk of electric shock or fire.
• Stop operation and close the window in storm or hurricane. If possible, remove the product from the
window before the hurricane arrives. There is risk of property damage, failure of product, or electric
shock.
• Do not open the inlet grill of the product during operation.( Do not touch the electrostatic filter,if the
unit is so equipped.) There is risk of physical injury, electric shock, or product failure.
• When the product is soaked (flooded or submerged), contact an Authorized Service Center.
There is risk of fire or electric shock.
• Be cautious that water should not enter the product. There is risk of fire, electric shock, or product
damage.