Table of Contents
Advertisement
Installer Setting - Installer Setting Code Table
Installer Setting Code Table
No.
Function
0
Mode Override
Ceiling Height
1
Selection
Group Control
2
Auxiliary heater
M ode Override
This Function is only for Non-Auto Changeover H/P model.
Ceiling Height S election
Indoor unit connected to wired remote controller operate as wired remote controller setting.
Group Control
This function is only for group control. Please don't set this function in case of non-group
control.
After setting Group Control of the product, turn off the power then turn it back on after 1
minute.
Auxiliary heater
This function is only applied to models with Auxiliary Heater function being activated.
Function Code
0 : Set to Master
0
1 : Set to Slave
1 : Standard
2 : Low
1
3 : High
4 : Super High
0 : Set to Master
2
1 : Set to Slave
2 : Check Master/Slave
3 : Set to Auxiliary heater
2
4 : Cancel Auxiliary heater
5 : Check Auxiliary heater Installation
S etting Value
Installation
R emote Controller LCD
Installation Manual 23
Advertisement
Table of Contents
