Table of Contents
Advertisement
Installation of Decorative Panel
The decorative panel has its ins tallation
direction.
B efore ins talling the decorative panel,
always remove the paper template.
1
Remove the packing and take out air inlet
grille from front panel.
Front
grille
2
Remove the Corner covers of the panel.
Coner
cover
3
Fit the panel on the unit by inserting hooks
as shown in picture.
4
Insert two screws on diagonal corners of
panel. Do not tighten the bolts completely.
(The fixing screws are included in the
indoor unit box.)
Check the alignment of panel with the ceil-
ing. Height can be adjusted using hanging
bolts as shown in picture. Insert the other
two screws and tighten all screws com-
pletely.
5
Fit the corner covers.
6
Open two screws of control panel cover.
Screw
7
Connect one display connector and two
vane control connectors of front panel to
indoor unit PCB.
The position marking on PCB is as:
Display connector : CN-DISPLAY
Vane control connector: CN-VANE 1,2
CN-VANE 1,2
8
Close the cover for control box.
9
Install the air inlet grille and Filter on the
panel.
Installation Manual 17
Installation
CN-DISPLAY
Advertisement
Table of Contents
