Operation Mode - LG LSN090HYV Product Data Book
Hide thumbs
Also See for LSN090HYV:
- Svc manual (9 pages) ,
- Overview (20 pages) ,
- Specification (2 pages)
Table of Contents
Advertisement
6RMI0-04C
The controls will look like the following.
5
6
4
2
7
ON
11
8
13
15
Operation Mode
Cooling Operation
Auto Operation or Auto Changeover
Healthy Dehumidification Operation
Heating Operation
• Cooling Model( ), Heat Pump Model(
P/No:6711A20128R
• Applied Model
: LS240HSV2 / LS307HV2 / LS360HV2
NOTICE
• To use the functions printed in blue at the bottom of the buttons press 2
required functionbutton. Pressing the 2ndF button activates the blue printed function of the respective
button. To cancel the functionpress the 2nd F button again else it will automatically cancel if remains idle
after 10 seconds.
Signal transmitter
1
3
10
CANCEL
9
OFF
SET
12
AUTO CLEAN
17
19
18
14
16
Flip-up door
(opened)
)
Inverter Single
1. START/STOP BUTTON
Used to turn off/on the unit.
2. OPERATION MODE SELECTION BUTTON
Used to select the operation mode.
3. ROOM TEMPERATURE SETTING BUTTONS
Used to select the room temperature.
4. INDOOR FAN SPEED SELECTOR BUTTON
Used to select fan speed in four steps
low, medium, high and CHAOS.
5. JET COOL/HEAT BUTTON
Used to start or stop the speed cooling/heating.
(It operates fan in super high speed)
6. CHAOS SWING BUTTON
Used to stop or start louver movement and set the
desired up/down airflow direction.
7. ON/OFF TIMER BUTTONS
Used to set the time of starting and stopping
operation.
8. TIME SETTING BUTTONS
Used to adjust the time.
9. TIMER SET/CANCEL BUTTON
Used to set and to cancel the timer operation.
10. SLEEP MODE AUTO BUTTON
Used to set sleep mode auto operation.
11.
AIR CIRCULATION BUTTON(OPTIONAL)
Used to circulate the room air without cooling or heating.
ENERGY-SAVING COOLING MODE BUTTON
(OPTIONAL) For inverter type models
12. ROOM TEMPERATURE CHECKING BUTTON
Used to check the room temperature.
13. PLASMA BUTTON(OPTIONAL)
Used to start or stop the plasma-purification function.
14. HORIZONTAL AIRFLOW DIRECTION CONTROL
BUTTON (OPTIONAL)
Used to set the desired horizontal airflow direction.
15. RESET BUTTON
Used prior to resetting time.
16. 2nd F BUTTON
Used prior to using modes printed in blue at the
bottom of buttons.
17. AUTO CLEAN BUTTON(OPTIONAL)
Used to set auto clean mode.
In some models this button has a 2nd function of LED
luminosity control.
18. ˚C TO ˚F SWITCHING BUTTON
Used to switch temperature reading from Centigrade to
Fahrenheit.
19. LCD LUMINOSITY BUTTON(OPTIONAL)
Used to adjust LCD luminosity.
F button first and then the
nd
Remote controller
Hide quick links:
Advertisement
Table of Contents
