Attaching Lcd Options - NEC MultiSync LCD4010 User Manual
Hide thumbs
Also See for MultiSync LCD4010:
- User manual (84 pages) ,
- Specifications (2 pages) ,
- Manual (37 pages)
Table of Contents
Advertisement
Attaching LCD Options
You can attach mounting accessories to the LCD monitor in one of
the following two ways:
1. In the upright position
2. Lay the screen face down
Table
To avoid damaging the screen face, place the protective sheet on
the table underneath the LCD. The protective sheet was wrapped
around the LCD in the original packaging. Make sure there is noth-
ing on the table that can damage the monitor.
This device cannot be used or installed without the Tabletop Stand
or other mounting accessory. For proper installation it is strongly
recommended to use a trained, NEC authorized service person.
Failure to follow NEC standard mounting procedures could result in
damage to the equipment or injury to the user or installer. Product
warranty does not cover damage caused by improper installation.
Failure to follow these recommendations could result in voiding your
warranty.
When using mounting accessories other than NEC compliant and
approved, they must comply with the VESA-compatible mounting
method.
NEC strongly recommends using screws M6 size and
10mm in length. If using screws longer than 10mm, check the depth
of the hole. (Recommended Fasten Force: 470-635N•cm)
NEC recommends using mounting interface that comply with UL1678
standard in North America.
3. Ventilation Requirements for enclosure
mounting
To allow heat to disperse, leave space between surrounding
objects as shown in the diagram below.
4. To prevent the LCD Monitor from
falling down
Fasten the LCD monitor to a wall using a cord or chain which is
sufficient to support the weight of the LCD monitor (approx. 27.5kg
for the LCD4010 and approx. 32.8kg for the LCD4610).
Before moving the LCD monitor, the cord or chain should be re-
Protective Sheet
moved.
Clamper
Tabletop Stand
5. To prevent use of Main Power Switch
To prevent the use of the Main Power Switch, if desired, please at-
tach the Main Power Switch cover which is included as an acces-
sory.
NOTE: With the main power switch cover in place, the main power
switch can not be turned off. To turn the power off, remove the
main power switch cover and turn off the switch, or remove the
power cord from the AC Inlet at the back of the monitor.
English-5
1-6
Screw Holes
Cord or Chain
Screw
Screw
Main switch cover
- Quick Links:
- Control Panel
Hide quick links:
Advertisement
Table of Contents
