SAFETY PRECAUTIONS IMPORTANT SAFETY NOTICE Many electrical and mechanical parts in this chassis have special safety-related characteristics. These parts are identified by in the Schematic Diagram and Replacement Parts List. It is essential that these special safety parts should be replaced with the same components as recommended in this manual to prevent Shock, Fire, or other Hazards.
SERVICING PRECAUTIONS CAUTION: Before servicing receivers covered by this service unit under test. manual and its supplements and addenda, read and follow the 2. After removing an electrical assembly equipped with ES SAFETY PRECAUTIONS on page 3 of this publication. devices, place the assembly on a conductive surface such as NOTE: If unforeseen circumstances create conflict between the aluminum foil, to prevent electrostatic charge buildup or...
Page 5
IC Remove/Replacement Some chassis circuit boards have slotted holes (oblong) through Circuit Board Foil Repair which the IC leads are inserted and then bent flat against the Excessive heat applied to the copper foil of any printed circuit circuit foil. When holes are the slotted type, the following technique board will weaken the adhesive that bonds the foil to the circuit should be used to remove and replace the IC.
SPECIFICATION NOTE : Specifications and others are subject to change without notice for improvement. 1. Application range (4) Specification and performance of each parts are followed each drawing and specification by part number in This spec sheet is applied to the 42"/37" LCD TV used LP7BA accordance with BOM.
Page 7
5. General Specification Item Specification Remark Panel 42" TFT WXGA LCD 37" TFT WXGA LCD Frequency range H : 31 ~ 61Khz PC Input V : 56 ~ 75Hz Control Function 1) Contrast/Brightness 2) H-Position / V-Position 3) Tracking : Clock / Phase 4) Auto Configure 5) Reset Component Jack(480i/576i/480p/576p/720p/1080i) Y/Pb/Pr : 2EA...
ADJUSTMENT INSTRUCTION 1. Application Range 5. HDD Assembly Adjustment method This spec. sheet is applied to all of the LP7BA chassis(Saturn Analog DVR) manufactured at LG TV Plant 5.1. HDD FORMAT all over the world. 1) Assemble MAIN , DVR Board.
Page 11
6. EDID 7. ADC Calibration Caution RF/AV/S-VIDEO Component * Use the proper signal cable for EDID Download MSPG925FA NTSC Model:217 720P Model: 60 - Analog EDID : Pin3 exists - Digital EDID : Pin3 exists INPUT AV3-ZF VIDEO1 -MA Pattern:65 1024*768 60Hz SELECT AV1-TB * 100% Color Bar...
Page 12
7.2 Adjustment of Component. 7.3 Adjustment of RGB * Required Equipments * Required Equipments - Remote controller for adjustment - Remote controller for adjustment - 802F Pattern Generator, Master (MSPG-925FA), etc - 802F Pattern Generator, Master (MSPG-925FA), etc - MSPG-925FA Pattern Generator - MSPG-925FA Pattern Generator (Which has 720p@60Hz YPbPr signal : 100% Color (Which has XGA [1024*768] 60Hz PC Format output...
8. White Balance * Caution : Before White-balance, the AV ADC should be done. => Notice - Do the white balance adjustment under the 10LUX - Before white balance, press the In-start key 2times and do the reset like Fig.5 - Use the Torino inner pattern(216 gray pattern) - To enter White-balance mode,press the IN-START key 2times.