Table of Contents
Advertisement
Installation Map
NOTICE
Installation parts you should purchase.
Air Discarge
Operation Indication Lamps/
Signal Receptor
Forced Operation Button
Air Inlet Vents
Air Outlet Vents
NOTE: refrigerant line wall thickness must be at least 0.8 mm(0.031 inch)
Installation plate
Sleeve
Bushing-Sleeve
Putty(Gum Type Sealer)
Bend the pipe as closely
on the wall as possible,
but be careful that it
doesn't break.
Vinyl tape (Wide)
• Apply after carrying out a
drainage test.
• To carry out the drainage
test, remove the air filters
Saddle
and pour water into the heat
exchanger.
Gas side piping
Liquid side piping
Additional drain pipe
Vinyl tape (Narrow)
Drain Hose
Connecting cable
(Optional Parts)
Base Plate
Installation
(Optional Parts)
(Optional Parts)
Installation Manual 9
Advertisement
Table of Contents
