Table of Contents
Advertisement
Chapter 7. DEDICATED INSTRUCTIONS FOR SPECIAL MODULES
7.2.2 Write to Buffer Memory ...RPUT
Execution condition
<Format>
Format
SI
St
S
Head address of the device to be stored the data write.
D
Head address of the specific module's buffer memory to write data
n
Word number of data to be write
SS
Area used for indicating the status information during link
REMARK
If the content is write to the buffer memory of the RTD input module by use of RPUT, be sure to make the
program so that execution condition can transit from 0 to 1(Rising Edge :
Otherwise, The content in the buffer memory of the RTD input module will not be changed with a new data.
<Format>
[Configuration]
[Write to buffer memory]
1) The content in the D100 to D108(9 words) of the devices in the CPU module
2) Will be written to addresses 0 to 8 of the buffer memory of the RTD input module, and
3) Information on the communication status is stored to D0
[program]
for RPUT
[ RPUT
Description
Upper(AB) : Code value for RTD input module
G3F - RD3A : 04h
G4F - RD2A : 84h
Lower(CD) : Slot No. of the communications module of the local station
Setting range : 0 to 7
Upper(EF) : Slot No. of the RTD
Input module loaded onto the remote station
Setting range : 0 to 31
Lower(GH) : Station No. of the communications module loaded onto the
remote station(RBEA)
Setting range : 0 to 63
GM3-
GM3-
G3I-
G3I-
PA1A
CPUA
A24A
A22A
condition for
SI
St
S
D
n
Slot 4
G3Q-
G3Q-
G3L-
RY4A
RY2A
FUEA
GM3-
G3L-
G3I-
PA1A
RBEA
D24A
Station No. 11
(0Bh)
7 - 4
SS ]
Available data type
Integer
Integer
M,P.K.L.T,C,D, #D
Integer
Integer, D
M,P.K.L.T,C,D, #D
)
Slot 1
G3F-
RD3A
Advertisement
Table of Contents
Troubleshooting
