Table of Contents
Advertisement
Available languages
Available languages
ADVANCED FUNCTIONS
16
Operating the air conditioner
without the remote control
You can use the On/O button of the indoor
unit to operate the air conditioner when the
remote control is unavailable. However, the
fan speed is set to high.
1
Open the front cover.
- Lift up both sides of the cover slightly.
* The feature can be changed according to
type of model.
2
Press the On/O button.
* The feature can be changed according to
type of model.
- For cooling and heating models, the oper-
ation mode changes, depending on the
room temperature.
Room temp.
Set temp.
Above
21°C(69.8°F)
And
23°C(73.4°F)
Below
24°C(75.2°F)
Above
22°C(71.6°F)
24°C(75.2°F)
- For cooling-only models, the temperature
is set to 22°C (71.6°F).
ON/OFF
button
Operation
mode
Dehumidify-
ing operation
Cooling
operation
Restarting the air conditioner
automatically
When the air conditioner is turned on again
after a power failure, this function restores the
previous settings. This function is a factory de-
fault setting.
Disabling auto restart
1
Open the front cover.
- Lift up both sides of the cover slightly.
* The feature can be changed according to
type of model.
2
Press the On/O button and hold it for 6
seconds.
- The unit will beep twice and the lamp will
blink 6 times.
* The feature can be changed according to
type of model.
- To re-enable the function, press the On/
O button and hold it for 6 seconds. The
unit will beep twice and the blue lamp will
blink 4 times.
!
NOTE
If you press and hold the On/O button
for 3 – 5 seconds instead of 6 seconds,
the unit will switch to the test operation.
In the test operation, the unit blows out
strong air for cooling for 18 minutes and
then returns to the factory default set-
tings.
ON/OFF
button
Advertisement
Table of Contents
