Table of Contents
Advertisement
OPERATING INSTRUCTIONS
14
OPERATING INSTRUCTIONS
Cooling Mode
|
1
Press
button to turn on the indoor.
a
2
Press
button to select Cooling opera-
tion mode.
- When canceling operating, press
ton once more.
3
Adjust the desired temperature by press-
ing (
) buttons.
- If desired temperature is higher than
room temperature, cooling cannot be con-
ducted.
- Set the temperature lower than the room
temperature
- Setting Temp Range : 18 °C~30 °C.
NOTE
!
What is 3 minutes delay function?
The reason that cold wind is not coming out
when operating the unit after turning off the
cooling is because of the function to protect
compressor. Cold wind will be coming out
when compressor is operated after 3 minutes.
Heating Mode
Heat Pump
|
1
Press
button to turn on the indoor.
d
2
Press
button to select Heating opera-
tion mode.
- When canceling operation, press
ton once more.
3
Adjust the desired temperature by press-
ing (
) buttons.
- If desired temperature is lower than room
temperature, heating cannot be con-
ducted.
- Set up desired temperature higher than
the room temperature
- Setting Temp Range : 16 °C~30 °C.
NOTE
!
Preheating operation
When conducting heating operation at the
condition of low outdoor temperature, the
case that wind is not coming out for several
minutes under the state of lighting of de-
frost lamp may be occurred. This is the pre-
heating stage to supply warm wind which
will be supplied subsequently in short time.
Airflow Setting
We can simply adjust the desired airflow di-
rection.
Up/Down Airflow Direction Control
|
but-
1
Press
2
Press
swing up and down.
3
Press
louver at the desired airflow direction.
Left/Right Airflow Direction Control
1
Press
2
Press
swing left and right.
3
Press
louver at the desired airflow direction.
<Airflow Setting Table>
Symbol
I
J
|
Fan Speed Setting
but-
1
Press
2
Press
- You can select the fan speed in four
steps Low, Mid, High, Super High.
Each time the button is pressed, the fan
speed mode is shifted.
- Air flow rate can be selected during the
cooling, heating, dehumidification, blow-
ing, and auto operation mode.
|
button to turn on the indoor.
I
button and the louvers will
I
button again to set the horizontal
|
button to turn on the indoor.
J
button and the louvers will
J
button again to set the vertical
Description
Up·Down : Vane move from up to
down automatically and continu-
ously
Left·Right : Vane move from left to
right automatically and continuously
|
button to turn on the indoor.
button to select fan speed.
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
