Table of Contents
Advertisement
Connecting a Personal Computer
Connecting your computer to your LCD monitor will enable you to display your computer's screen image.
Some display cards with a pixel clock over 162MHz may not display an image correctly.
Your LCD monitor displays proper image by adjusting the factory preset timing signal automatically.
<Typical factory preset signal timing>
Scanning frequency
Resolution
Horizontal
640 x 480
31.5 kHz
800 x 600
37.9 kHz
1024 x 768
48.4 kHz
1280 x 768
48 kHz
1360 x 768
48 kHz
1280 x 1024
64 kHz
1600 x 1200
75 kHz
1920 x 1080
67.5 kHz
•
If you use with a Macintosh device, set "Mirroring" to Off on your device.
Refer to your Macintosh's owner's manual for more information about your computer's video output requirements and any
special identifi cation or confi guration your monitor's image and monitor may require.
•
Input TMDS signals conforming to DVI standards.
•
To maintain display quality, use a cable that conforms to DVI standards.
Connecting a DVD Player or Computer with HDMI out
•
Please use an HDMI cable with HDMI logo.
•
It may take a moment for the signal to appear.
•
Some display cards or drivers may not display an image correctly.
Connecting a Computer with DisplayPort
•
Please use DisplayPort cable with DisplayPort compliance logo.
•
It may take a moment for the signal to appear.
•
Please note that DisplayPort connector does not supply power to the connected component.
•
Please note that when connecting a DisplayPort cable to a component with a signal conversion adapter, an image may not
appear.
•
Select DisplayPort cables feature a locking function. When removing this cable, hold down the top button to release the lock.
For using Touch Panel
1. Turn off the monitor.
1
2. Install the equipment.*
- Using slot 2 type PC:
Connect the slot 2 type PC into the option board slot.
NOTE: Please refer to the slot 2 type PC's manual for
connection.
NOTE: When you set option board accessory other than
slot 2 type PC, touch function may not work.
- Using external computer:
Connect the B type connector to the USB upstream port on the
left back side of the monitor and the A type connector to the
downstream port on the external computer (Figure 1).
3. Turn on the monitor.
*1: Please contact your NEC customer support for more detailed information.
Monitor Setting
Select the input signal.
- Using slot 2 type PC: Select [OPTION]
- Using external computer: Select the input signal which is
supplied by the PC connected to USB connector.
NOTE:
Touch function does not work in PIP mode.
Remarks
Vertical
60 Hz
60 Hz
60 Hz
60 Hz
60 Hz
60 Hz
60 Hz
Compressed image
60 Hz
Recommended resolution
English-15
B Type
A Type
A: Refl ective bar
B: Camera module*
Computer
2
*
Camera module consists of an infrared light source and a sensor.
Figure 1
2
Advertisement
Table of Contents
