Table of Contents
Advertisement
PIPE CONNECTIONS BETWEEN INDOOR AND OUTDOOR UNIT
28
PIPE CONNECTIONS BETWEEN INDOOR AND
OUTDOOR UNIT
- Pipe connections can be done on the front side or on the side according to the installation.
- Be sure to let 0.2 kgf/cm
- If Nitrogen was not flown during welding, many oxidized membranes may form inside the pipe
and disturb the normal operations of valves and condensers.
Front Pipe
Draw Out
Bottom Side Pipe
Draw Out
Preparation Work
- Use Knock Outs of Base Pan of the outdoor unit for Left/Right or Bottom pipe drawing outs.
Removal Area for Liquid/Gas pipe
bottom side connections.
CAUTION
!
• Do not give damage to the pipe/base during the Knock Out work.
• Proceed to pipe work after removing burr after Knock Out work.
• Perform sleeve work to prevent damage to the wire when connecting wires using knock Outs.
• Take care so that there is no thermal damage on the service valves of the outdoor unit.
(Especially packing part of service port.) Wrap the service valve with a wet towel when
brazing it as shown figure above.
2
Nitrogen flow in the pipe when welding.
Rear Side Pipe
Draw Out
Right Side Pipe
Draw Out
Refrigerant Pipe
Nitrogen
Nitrogen
Nitrogen
Direction
Direction
Direction
Taping
<Liquid pipe>
※Pictures may differ depending on the model.
Regulator
Valve
Nitrogen
Wet towel
<Gas pipe>
- Quick Links:
- Outdoor Units Information
- Electrical Wiring
Hide quick links:
Advertisement
Table of Contents
