Install Power Bar Onto Frame Supports; Check The Evenness; Bring Power Bar Into Position; Attach Power Bar To Frame Supports - NEC FA Series User Manual
Led wall bundle fine pitch led video display indoor
Hide thumbs
Also See for FA Series:
- Installation and maintenance manual (131 pages) ,
- Quick start manual (72 pages) ,
- User manual (105 pages)
Table of Contents
Advertisement
6.2 Install Power Bar onto Frame Supports
This section is a guide to mounting the Power bar onto the frame supports and describes the
following in more detail:
Prepare the frame supports so they are level.
Position the Power bar on the frame supports.
Then fix the Power bar onto the frame supports.
Table 9: Power Bar Installation Requirements
No. of People 2
Prerequisites
Frame support securely installed
Power bar/LED Wall not connected to mains
Tools
Alignment bar
Spirit level
Screwdriver
Equipment
Power bar
Check the Evenness
Use the Alignment bar and spirit level in combination to check the evenness between
the vertical frame supports.
If necessary, adjust top and bottom supports accordingly.
Bring Power Bar into Position
Bring the Power bar into position to align interface to anchoring point.
Align the locating pin of the Power bar to the frame support interface.
Figure 48: Wall Mounting: Attachment of Power Bar (5×5 Frameset)
Attach Power Bar to Frame Supports
Use M6×12 Screws (4 per frame support) to
attach Power bar onto the frame supports.
Check that the Power bar is level. If
necessary, adjust accordingly.
Tighten the screws.
Figure 49: Wall Mounting: Attachment of Power Bar (Detail)
© NEC Corporation 2019
42
Hide quick links:
Advertisement
Table of Contents
