Table of Contents
Advertisement
16. Function of Remote Controller
For VK/VL Chassis Models
The remote control transmits the signals to the system.
Remote Control
5
6
4
2
7
ON
OFF
11
8
13
Operation Mode
Cooling Operation
Auto Operation
Healthy Dehumidification Operation
Heating Operation
• Cooling Model( ), Heat Pump Model(
Signal transmitter
1
3
10
CANCEL
9
SET
AUTO CLEAN
12
14
Flip-up door
(opened)
)
1
START/STOP BUTTON
Operation starts when this button is pressed
and stops when the button is pressed again.
OPERATION MODE SELECTION BUTTON
2
Used to select the operation mode.
ROOM TEMPERATURE
3
SETTING BUTTONS
Used to select the room temperature.
INDOOR FAN SPEED SELECTOR
4
Used to select fan speed in four steps
low, medium, high and CHAOS.
JET COOL
5
Used to start or stop the speed cooling/heating.
(Speed cooling/heating operates super high fan speed.)
CHAOS SWING BUTTON
6
Used to stop or start louver movement and
set the desired up/down airflow direction.
ON/OFF TIMER BUTTONS
7
Used to set the time of starting and stopping operation.
TIME SETTING BUTTONS
8
Used to adjust the time.
TIMER SET/CANCEL BUTTON
9
Used to set the timer when the desired time is obtained
and to cancel the Timer operation.
SLEEP MODE AUTO BUTTON
10
Used to set Sleep Mode Auto operation.
AIR CIRCULATION BUTTON
11
Used to circulate the room air without cooling or heating.
ROOM TEMPERATURE CHECKING BUTTON
12
Used to check the room temperature.
RESET BUTTON
13
Initialize remote controller.
2nd F Button
14
Used prior to using modes printed in blue at the bottom
of buttons.
Ceiling & Floor, Ceiling Suspended (50Hz, R22)
(Cooling Only)
(Heat Pump)
89
Hide quick links:
Advertisement
Table of Contents
