PIONEER ELECTRONICS (USA) INC. P.O.Box 1760, Long Beach, CA 90801-1760 U.S.A. PIONEER EUROPE NV Haven 1087 Keetberglaan 1, 9120 Melsele, Belgium PIONEER ELECTRONICS ASIACENTRE PTE.LTD. 253 Alexandra Road, #04-01, Singapore 159936 C PIONEER CORPORATION 2003 K-ZZW. MAY 2003 Printed in Japan...
WARNING This product contains lead in solder and certain electrical parts contain chemicals which are known to the state of California to cause cancer, birth defects or other reproductive harm. Health & Safety Code Section 25249.6 - Proposition 65 AVD-W6210/UC...
1. SPECIFICATIONS - AVD-W6210/UC General ..............14.4 V DC (10.8 — 15.1 V × allowed) Power source Grounding system ............Negative type Max. current consumption ..........1.5 A Backup current ..............1 mA or less Display Unit Screen size/Aspect ratio ..........6.5 inch wide/16:9 (effective display area: 154 ×...
Page 5
- AVD-W6210/EW General ..............14.4 V DC (10.8 — 15.1 V × allowed) Power source Grounding system ............Negative type Max. current consumption ..........1.5 A Backup current ..............1 mA or less Display Unit Screen size/Aspect ratio ..........6.5 inch wide/16:9 (effective display area: 154 ×...
2. EXPLODED VIEWS AND PARTS LIST 2.1 PACKING(AVD-W6210/UC) AVD-W6210/UC...
Page 7
- Screws adjacent to ∇ mark on the product are used for disassembly. - For the applying amount of lubricants or glue, follow the instructions in this manual. (In the case of no amount instructions, apply as you think it appropriate.) - PACKING(AVD-W6210/UC) SECTION PARTS LIST Mark No. Description Part No.
Page 15
See Contrast table(2) 24 Knob Unit See Contrast table(2) 25 Bolt See Contrast table(2) (2) CONTRAST TABLE AVD-W6210/UC and AVD-W6210/EW are constructed the same except for the following: Part No. Mark No. Symbol and Description AVD-W6210/UC AVD-W6210/EW 19 Holder(B)-L CZN5455...
TC7S08FU 18 CCREM NAVIGATION CCSYNC ISOLATER ONSEI+ IC 1331 IC 1121 ONSEI- NJM4558E TC4S66F AV SEL ISOLATER IC 1321 CCAUL TA2050F CN1301 VTR1V FU1301 IC 1 CXA2 ISOLATER IC 1301 VTR1AL TA2050F VTR2V FU1311 ISOLATER IC 1311 VTR2AL TA2050F AVD-W6210/UC...
Page 17
PE5375A bsens Q1842 Q1844 MONPWR asens pbsen Q1801 IC 1801 SWAC56 TA78L05F bksens CN4201(AVD-W6210/UC) Q1802 SWACPW CN2003, 2002(AVD-W6210/EW) Q1201 Q1202 MOREM RGB 75Ω DRIVER IC 1151 BA7660FS BUFFER IC 1171 CSYNC TK15405BMI IC 1131 IC 1141 NJM4558E TDA7052BT AV SELECTOR...
Note: When ordering service parts, be sure to refer to " EXPLODED VIEWS AND PARTS LIST" or "ELECTRICAL PARTS LIST". TOUCH PANEL Large size SCH diagram DIMMER RESET Guide page Detailed page EEPROM FILTER AVD-W6210/EW ONLY & A/D 8bit OSD CONTROL Y/C SEPARAT INTERFACE MONITOR UNIT Consists of MONITOR PCB KEYBOARD PCB AVD-W6210/UC...
Page 23
Therefore, when replacing, be sure to use parts of ← Symbol indicates a capacitor. identical designation. ← No differentiation is made between chip capacitors and 0.022 R022 discrete capacitors. : The power supply is shown with the marked box. AVD-W6210/UC...
NAVIGATION RGB INPUT AUDIO O > SOURCE SELECTOR POWER SUPPLY AUDIO SECTION SYSTEM SECTION > > V1 AUDIO ISOLATOR MONITOR SECTION > > > V2 AUDIO ISOLATOR SENSOR BACK UP AND REMOTE CONTROL POWER SUPPLY MONITOR ON BACK PARKING ON/OFF NAVIGAT AVD-W6210/UC...
Page 35
MOTHER UNIT MONITOR SPEAKER ATTENUATION AND MUTE MONITOR SPEAKER AUDIO OUTPUT SOURCE SELECTOR BUFFER RGB 75Ω DRIVER AUDIO OUTPUT BUFFER MUTE REMOTE CONTROL BUFFER BUFFER MICRO COMPUTER 75Ω VIDEO DRIVER > > MONITOR ON DETACH ON/OFF NAVIGATION AVD-W6210/UC...
For further information for respective destinations, be sure to check with the schematic dia- gram. 2.Viewpoint of PCB diagrams Capacitor Connector MONITOR PCB SIDE A SIDE B P.C.Board Chip Part TOUCH PANEL LCD PANEL AVD-W6210/UC...
Page 43
SIDE A SPEAKER LCD PANEL CN1841 (AVD-W6210 CN4471 CN2001 /UC) (AVD-W6210/EW) AVD-W6210/UC...
Page 55
1323 CKSRYB105K10 Monitor Unit Consists of 1324 CKSRYB105K10 Monitor PCB 1325 CEV220M16 Keyboard PCB 1326 CEV100M16 1327 CCSRCH471J50 Unit Number : CWM8887 (AVD-W6210/UC) 1328 CCSRCH471J50 CWM8852 (AVD-W6210/EW) Unit Name : Monitor Unit 1331 CKSRYB105K10 1332 CKSRYB105K10 MISCELLANEOUS 1333 CKSRYB104K16 1334...
Page 56
=====Circuit Symbol and No.===Part Name Part No. =====Circuit Symbol and No.===Part Name Part No. ------ ------------------------------------------ ------------------------- ------ ------------------------------------------ ------------------------- IC 4411 NJM062V 4352 Diode (AVD-W6210/EW) UDZS5R6(B) IC 4441 OZ961IS 4353 Diode (AVD-W6210/EW) UDZS5R6(B) IC 4442 TA78L05F 4354 Diode (AVD-W6210/EW) UDZS5R6(B) IC 4601...
Page 67
Touch panel Y coordinates 16 Touch panel caliblation adjustment result Touch panel outermost circumference inspection adjustment result Outermost Xmin Outermost Ymin Outermost Xmax Outermost Ymax Check sum address (00H-1BH) Common reverse output center(Reference) Clock phase adjustment initial value Don't care AVD-W6210/UC...
Page 68
EEPROM. 2) BRIGHT and COM AMP data The BRIGHT and COM AMP adjustments are made by using the same 2-screen IC register(SA22h B7-2: common reverse output amplitude). Therefore, adjusting one of the data will change the other one. AVD-W6210/UC...
Page 69
[0 - 255] BL M FFFF Backlight point (low) [0 - 255] BL L Note: The dimmer point data is memorized in the EEPROM, but not treated as a CS item. It's because the settings are adjustable by the user. AVD-W6210/UC...
Page 70
(DEC) Clock phase adjustment [0 - 15] DOT CLK Clock phase adjustment (initial) [0 - 15] [FACTORY [0-255] COM DC Common reverse output center [0-255] [FACTORY Common reverse output center adjustment (initial) * CS(Check Sum)display is not performed. AVD-W6210/UC...
3) If the checking result is within the allowable range, "OK" will be displayed in the center of the screen. If not, "NG" will be displayed. Reference value AFTER initial value BEFORE initial value (EEPROM setting initial value) AFTER tolerance value 25-65 225-265 30-70 220-260 AVD-W6210/UC...
Page 72
[ 9 9 9 . 9 9 9 ] [ 9 9 9 . 9 9 9 ] [Adjustment steps] 1) Push the touch panel, then coordinates before and after correction are displayed. Pressing the [BACK] key will return the display to the menu screen. AVD-W6210/UC...
The calculated value from coordinates of EEPROM data ± 0 BRIGHT ± 0 CONTRAST WIDE MODE Full size [Touch panel test mode] MVIPW MFLPW DIMMER The calculated value from coordinates of EEPROM data ± 0 BRIGHT ± 0 CONTRAST WIDE MODE Full size AVD-W6210/UC...
7. GENERAL INFORMATION 7.1 DIAGNOSIS 7.1.1 DISASSEMBLY Monitor Assy *) AVD-W6210/EW is different partially from the following photos, but disassembly method is the same. Removing the Case (Fig.1) Remove the four screws. Disconnect the connector and then remove the Case.
Page 75
Power Supply Assy Removing the Case (Fig.1) Remove the six screws and then remove the Case. Case Fig.1 Removing the Mother Unit (Fig.2) Straighten the tabs at four locations indicated. Remove the Mother Unit. Fig.2 Mother Unit AVD-W6210/UC...
Page 78
Not used VSS0 Power supply Connection of crystal for oscillating main system clock Connection of crystal for oscillating main system clock Connect to GND Not used Connect to GND AVDD A/D converter power supply AVREF A/D converter reference voltage AVD-W6210/UC...
Page 79
Be careful in handling them because they are very liable to be damaged by electrostatic induction. NJM4558E A OUTPUT A -INPUT B OUTPUT A +INPUT B -INPUT B +INPUT TK15405BMI STANDBY 1 75Ω DRIVER VOUT 2 Clamp VSAG 3 AVD-W6210/UC...
Page 80
9. 6 M (8LSB) ROUT PLLDVDD2 CP1/CP2 Ped.Clamp (8LSB) Green 1/ 6 8. 0 M BIAS2-35 CKIN Li m Analog Analog GOUT Blue VDD Vss AGS1 37 38 39 40 41 42 43 44 45 46 47 48 49 50 *S-80835CNNB-B8U AVD-W6210/UC...
Page 81
REMIN Remote control data input VDDSENS Power supply sense input 63,64 Not used LCDLR LCD panel L / R output TVIND Not used VSS0 VDD1 Power supply Crystal oscillator connection pin Crystal oscillator connection pin Not used Not used AVD-W6210/UC...
Page 82
Analog key data input 3 KDT4 Analog key data input 4 *PE5376A R1130H251B VOUT VREF CURRENT LIMIT VDET *FA7700V UVLO VREF 0.3V ON/OFF VREF 2.2V 5.5V S. C. P 1.5V BIAS S. C. DET 2.2V 1.5V Power Good Signal ON/OFF 0.88V ER. AMP AVD-W6210/UC...
Page 83
Port output Port output P1/R Port output or R output Port output P3/G Port output or G output Port output P5/B Port output or B output Horizontal synchronous signal input VERT Vertical synchronous signal input Positive power supply terminal *PD5703A AVD-W6210/UC...
This receiver receives signals from the Switches the display to the desired remote control supplied with the indications. Use to switch between Pioneer Navigation unit and other AV navigation images and the images of equipment. each source. 2 Ambient light sensor 7 NAVI button Senses ambient light.
Page 86
Receives stereo audio, as from a VCR, Use to connect a navigation unit or other DVD player or other AV equipment. Pioneer AV equipment. 6 AV IN2 RCA video input (yellow) Receives video, as from a VCR, DVD player, back-up camera or other AV equip- ment.
Page 87
Connecting method Ground side Note: • The position of the parking brake switch Clamp the parking Clamp firmly depends on the vehicle model. brake switch power with needle-nosed supply side lead. pliers. AVD-W6210/UC...
Page 88
Commercial RCA cable (sold separately) To video output Commercially Brown available portable video component or back-up camera with RCA output To audio output Note: • When other AV equipment is connected to the AV IN2 input, setting may be required. AVD-W6210/UC...