Frigidaire PLEW30S3FCB Installation Instructions Manual
27", 30" warmer drawer
Hide thumbs
Also See for PLEW30S3FCB:
- Use & care manual (8 pages) ,
- Wiring diagram (2 pages) ,
- Installation instructions manual (12 pages)
Advertisement
Available languages
Available languages
Quick Links
iNSTALLATiON
AND SERVICE MUST BE PERFORMED BY A QUALiFiED
iNSTALLER.
iMPORTANT:
SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE.
READ AND SAVE THESE iNSTRUCTiONS
FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable
vapors and liquids in the
vicinity of this or any other appliance.
GENERAL iNFORMATiON
The Warmer Drawer can be used: As a stand alone appliance or as a cornbination Warmer Drawer with a built-in oven
mounted above
IMPORTANT: The warmer drawer must be installed on a surface leveled from left to right, rear to front and the surface
must be capable of supporting 100 pounds (45 Kg).
Warmer
Drawer Dimensions
NOTE: A 60" (1 52 cm) long cable is supplied with the
Warmer Drawer.
Stand Alone Installation
27"Models
30"Models
10" (25,4cm)
27" (68,6 cm)
23 3/8" (59.4cm)
10" (25,4cm)
30" (76,2 cm)
23 3/8" (59.4cm)
27"Models- Min.
Max.
30"Models- Min.
Max.
8 3/8"(21,3 cm)
8 5/8"(21,9 cm)*
8 3/8"(21,3 cm)
8 5/8"(21,9 cm)*
i!i!i!i!i!i!i!i!i!i!!i!ii!i!i_!iiiiiii_ii:i_!_
_i_i!_ii_i_!i_!i_!i_!i_!i_!_!i_!_i!_j
iiiiii!i!i!ii!iiii_
ii_i_i_i_ii_ii_iiiiilililililiiiill
¸¸¸¸¸
251/2" (64,8 cm) 235/8"(60cm)
253/4" (65,4 cm)
24"(61cm)
281/2" (72,4 cm) 235/8"(60cm)
283/4"(73cm)
24" (61cm)
iMPORTANT:
The Warmer
Drawer
runs off a single
phase three-wire
120 volt, 60 hertz, AC only electrical
supply with ground.
Combination
Warmer
Drawer/
30" (76 cm) Built-in
Oven Installation
Caution:
Two 3" (7,6 cm) wide X 3/
4" (1,9 cm) thick planks have to be
installed and they should be able to
support 200 pounds. (90,7 Kg)
B
J
" lJ
c
H* =10-1/8" (25.7 cm) Min. is a Critical
dimension and must he applied.
J** = 3" (7.6cm) Max. Electrical
Junction Box for wall oven can he
lower than warmer
drawer cutout or higher than walloven
cutout.
27" Models
10" (25,4cm)
271' ( 68,6 cm)
23 3/8" (59.4cm)
30" Models
10" (25,4cm)
30" (76,2 cm)
23 3/8" (59.4cm)
28½" (72,4cm) 23 5/8"(60 cm)1_" (3.8
8 5/8"(21,9cm)
283A ' ' (73 cm)
24"(61cm) di,,e,si0,
H
* Note: It is also possible to install this warmer drawer in a
height opening of 9_A" (23.5 cm). Please refer to page 3
for complete instructions.
Printedin UnitedStates
P/N 318201807
(0606)
Rev.
English - pages 1-4
Espa_ol-
paginas 5-8
Fran_ais - pages 9-12
Advertisement
Related Manuals for Frigidaire PLEW30S3FCB
Summary of Contents for Frigidaire PLEW30S3FCB
- Page 1 iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iNSTALLER. iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE. READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE. FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
-
Page 2: Important Safety Instructions
Locate the 2 anti-tip brackets supplied as shown on Important Notes to the Installer figure I. Fix them using 2 of the 4 black head Read all the instructions contained in these installation screws (10-16 X lY4") supplied. instructions before installing appliance. Slide the drawer into the cutout opening until the Remove all packing material from the appliance before... - Page 3 B.Installationfor a cutoutheightof 91/4 ( 23.5cm) (for30"Warmer Drawer only): 1. Locatethe 2 anti-tip bracketsand the 2 front supportssuppliedasshownon figure3. Fixthem SPACER using the 4 black head screws(10-16 X lY4") SCREW supplied 2. Install t he 4 spacers ( Figure 4 ) supplied under drawer asshown in figure5 using the4 screws ( 10-24 X %").
- Page 4 NOTES...
- Page 5 LA INSTALACION Y EL SERVICIO DEBEN SER EJECUTADOS POR UN INSTALADOR CAUFICADO. IMPORTANTE: GUARDE ESTAS INSTRUCCiONES PARA EL USO DEL INSPECTOR LOCAL DE ELECTRICIDAD. LEA Y GUARDE ESTAS INSTRUCCIONES PARA FUTURAS REFERENCIAS. F.__ PARA SU SEGURIDAD: No almacene o use gasoJina u otros vapores y Jiquidos...
- Page 6 Notas importantes para el instalador I. Instale los 2 brackets anti-volteo como muestro la figura I. I. Leatodas las instrucciones de instalaci6n antes de instalar Instale los usando 2 de los 4 tornillos negros (10-16 X I X") el electrodomestico. suministrados.
- Page 7 B.Instalaci6n del caj6n calentador con una abertura 9_/4 (23.5 cm) (para modelos de 30 pulgadas solamente) I. Localice los 2 bracketsanti-volteoy los 2 apoyos anteriores suministrados como mostrado en la figura 3. Instale los APOYO usando los4 tornillos negros (10-16 X I Y4 ") suministrados. 2.
- Page 8 NOTAS...
- Page 9 L'INSTALLATION ET L'ENTRETIEN DOIVENT ETRE EFFECTUE:S PAR UN INSTALLATEUR COMPETENT. iMPORTANT : CONSERVEZ CES iNSTRUCTiONS POUR L'INSPECTEUR D'I_LECTRICITE LOCAL. LISEZ ET CONSERVEZ CES iNSTRUCTiONS POUR REFI_RENCES ULTE_RIEURES. POUR VOTRE SECURITE: N'entreposez et n'utilisez pas d'essence ou autres gaz et liquides inflammables _ proximit_ de cet appareil ou de tout autre appareil m_nager.
- Page 10 I. Localisez les supports anti-bascules tel qu'indiqu_ a la Notes importantes _ I'installateur figure 1. Fixez-les _ I'aide des vis noires fournies (10-16 X I. Liseztoutes lesinstructions d'installation avant de proceder _A") I'installation de cet appareil. 2. Glissez le tiroir dans I'ouverture du d_coupagejusqu'a ce 2.
- Page 11 Installation pour une hauteur de d_coupage de 9% (23.5 cm) (Pour les modules de 30" seulement) Localisez les 2 supports anti-bascules et les 2 supports frontaux fournis comme indiqu6 a la figure 3. Fixez-les a ENTRETOISE I'aide des 4 vis noires fournies (10-16 X le 11/4") Installez les4 entretoises fournies (Figure 4) sous le tiroir comme indique a la figure 5 en utilisant les 4 vis (10-24 X 5/8").
- Page 12 NOTES...