Table of Contents
Advertisement
• ELECTRONIC CONTROLS
The controls will look like one of the following.
FAN SPEED
• Every time you push this button, it cycles through the settings as follows:
{High(F2)) → Low(F1)) → High(F2)}
MODE
-
Push this button to cycle through the modes from
→
→
COOL
FAN
HEAT
- COOL
• Fan runs continually for normal cooling operation.
- ENERGY SAVER
• The fan stops when the compressor stops cooling.
Fan will turn ON when the unit reaches setting temperature
even though compressor does not turn on due to 3 minutes
delay operation.
- FAN
• Fan operation without heating or cooling.
- HEAT
• Fan runs continually for normal heating operation.
TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of hours until shut-off.
• For your sleeping comfort, once the time is set the desired temperature will rise 2°F after 30 minutes, and once again
after another 30 minutes
• Push Timer to cycle through the settings from 1 Hour
Copyright ©2012 LG Electronics. Inc. All right reserved.
Only for training and service purposes
→
COOL.
POWER
• To turn ON the air conditioner, push this button.
To turn OFF the air conditioner, push this button
again.
• This button takes priority over any other button.
TEMPERATURE SETTING
• Use this button to automatically control the
temperature of the room.
The temperature can be set within a range of
54°F(12°C) to 86°F(30°C) by increments of
1°F(0.5℃).
• The setting temperature appears in the display.
→
→
→
2 Hours
...
12 Hours maximum.
- 7 -
LGE Internal Use Only
- Quick Links:
- Troubleshooting Guide
Hide quick links:
Advertisement
Table of Contents
