Advertisement
Quick Links
ICRRFTSMRN'I
18.0 Volt
C. R DLES_S.WORKLIGHT
Part No. 975815. -003
Use only with Craftsman
battery pack
and charger (both sold separately)
Extra bulb included
_1= CAUTION:
Read
Operating Instructions t:
product.
READ ALL INSTRUCTIONS
Safety Rules and
•
KNOW YOUR WORKLIGHT.
Read owner's
manual carefully. Learn its applications
and
limitations as well as the specific potential
hazards related to this light.
•
USE ONLY BATTERY PACK PART NUMBER
975284-001 WITH YOUR WORKLIGHT.
Any
attempt to use another battery pack will cause
damage to your light and could possibly explode,
cause a fire, or personal injury.
•
REMOVE BATTERY PACK FROM
WORKLIGHT
BEFORE REPLACING BULB OR
PERFORMING
ANY ROUTINE MAINTENANCE
OR CLEANING.
•
DO NOT DISASSEMBLE
YOUR LIGHT.
•
DO NOT PLACE WORKLIGHT
OR BATTERY
PACK NEAR FIRE OR HEAT. They may ex-
plode. Also, DO NOT dispose of a worn out
battery pack by incinerating.
•
DO NOT STORE YOUR WORKLIGHT
IN A
DAMP OR WET LOCATION. ALSO, DO NOT
STORE IN LOCATIONS WHERE THE TEM-
PERATURE
MAY REACH OR EXCEED 120°F.
For example, outside sheds, vehicles, or metal
buildings in the summer.
•
DO NOT PERMIT CHILDREN TO USE
WORKLIGHT
UNSUPERVISED.
It is not a toy.
The temperature of the bulb can become hot
after being on for an extended period of time.
This hot temperature may cause burn injury if
touched.
KEEP WORK AREA CLEAN. Cluttered areas
and benches invite accidents.
AVOID DANGEROUS
ENVIRONMENT.
KEEP LIGHT DRY, CLEAN, AND FREE FROM
OIL AND GREASE. Always use a clean cloth
when cleaning. Never use brake fluids, gasoline,
petroleum-based products or any strong solvent
to clean your light.
STAY ALERT. Watch what you are doing and
use common sense. Do not rush.
CHECK DAMAGED PARTS. Before further use
of this light, a part that is damaged should be
carefully checked to determine that it will operate
properly and perform its intended function. A part
that is damaged should be properly repaired or
replaced.
IMPORTANT
SAFETY
RULES
FOR BA'I-I'ERY
TOOLS
USE ONLY THE CHARGER RECOMMENDED
FOR USE WITH YOUR WORKLIGHT.
Do not
substitute any other charger. Use of another
charger could cause batteries to explode causing
possible serious injury.
•
Your battery tool should be charged in a location
where the temperature is more than 50°F but
less than IO0°F.
Under extreme usage or temperature conditions,
battery leakage may occur. If liquid comes in
contact with your skin, wash immediately with
soap and water, then neutralize with lemon juice
or vinegar. If liquid gets in your eyes, flush them
with clean water for at least 10 minutes, then
seek immediate medical attention.
•
WHEN SERVICING USE ONLY IDENTICAL
CRAFTSMAN
REPLACEMENT
PARTS.
IMPORTANT
SAFETY
INSTRUCTIONS
FOR
CHARGER
•
Before using battery charger, read all instructions
and cautionary markings in this manual, on
battery charger, and product using battery charger.
,_,
WARNING:
To reduce the risk of injury, charge
only nickel-cadmium
type rechargeable batteries.
Other types of batteries may burst causing
personal injury and damage.
Advertisement
Related Manuals for Craftsman 315.110990
Summary of Contents for Craftsman 315.110990
- Page 1 ICRRFTSMRN'I 18.0 Volt C. R DLES_S.WORKLIGHT Part No. 975815. -003 Use only with Craftsman and charger (both sold separately) Extra bulb included _1= CAUTION: Read Operating Instructions t: product. READ ALL INSTRUCTIONS • KNOW YOUR WORKLIGHT. Read owner's manual carefully. Learn its applications limitations as well as the specific potential hazards related to this light.
- Page 2 RULES FOR SAFE OPERATION • Do not expose to rain or snow. • To reduce the risk of damage to charger body and cord, pull by charger body rather than cord when disconnecting charger. An extension cord should not be used unless absolutely necessary.
- Page 3 SWITCH See Figure 2. To turn your light on and off, depress switch trigger. MULTI-POSITION HEAD MULTI-POSITION HEAD See Figure 2. Your worklight has the feature of a multi-position head that has positive stop clicks at each position. Rotate head to the desired position as shown in the arrows in figure 2.