Table of Contents
Advertisement
Figure 31
#2
assembly
Pump
assembly
Tube #1
Rubber
elbows(3)
14. Connect the condensate pump to the ICR relay of
the terminal of the board as shown in Figure 32 &
34 whichever is applicable Make sure to fasten the
pump wire through the wire clip on the back side of
the control barrier as shown in Figure 33.
Figure 32
BL
p
Copyright ©2010 LG Electronics. Inc. All right reserved.
Only for training and service purposes
Spraying
Tube
Tube #2
BL
15. Assembly the unit back following the reverse order
of disassembly.
NOTE: All tube should be inserted into rubber elbows
by at least 1/2"
Figure 33
Figure 34
- 27 -
LGE Internal Use Only
Advertisement
Table of Contents
