Table of Contents
Advertisement
File location
File location
The File location will not appear on the label on the control PCB.
• Turn the power to the jig ON
• Use the MODEL up or down to select the correct file.
*To use the MODEL up/down keys. Press either key for 3 seconds and release the key, you will see
the model id disappear and only the number will be shown in the upper left.
*Quickly use the up/down keys to scroll to the file in location number 1. The file will load after a
few seconds. The file name (42X2DN05B) appears in the screen on the jig.
NOTE: To use any key on the jig you must hold the key down for at least 3 seconds.
•Apply AC power to the jig with the switch on the jig OFF and apply AC
to the TV. Only one LED will be lit.
Digital PCB
•Press the main AC power switch to the ON position on the TV. These
additional LED's will be lit. If the TV is in the ON state when you connect
AC, the unit will turn itself on. Turn on the jig.
Plasma Training
Panel model
Panel model
SOFTWARE UPDATES
Rom version
Rom version
87
Software Updates
Advertisement
Table of Contents
Troubleshooting
