Table of Contents
Advertisement
Quick Start
To attach the Stand neck and Base Stand to the LCD Stand:
1. Attach the Stand neck to the monitor. And then, attach the Base Stand to the Stand.
The locking tabs on the Base Stand should fi t into the hole on the Stand (Figure 1).
To connect the LCD monitor to your system, follow these instructions:
1. Turn off the power to your computer.
2. For a PC or MAC with DVI digital output: Connect the DVI signal cable (not included)
to the connector of the display card in your system (Figure A.1). Tighten all screws.
For a PC with Analog output: Connect a 15-pin mini D-SUB signal cable to the
connector of the display card in your system (Figure A.2).
For a MAC: Connect a Macintosh cable adapter (not included) to the computer,
then attach
the 15-pin mini D-SUB signal cable to the Macintosh cable adapter (Figure A.3).
NOTE:
Some Macintosh systems do not require a Macintosh cable adapter.
For a PC with DisplayPort output: Connect the DisplayPort cable to the connector of the display card in your system
(Figure A.4).
Figure A.1
3. Connect all cables to the appropriate connectors (Figure C.1).
NOTE:
Incorrect cable connections may result in irregular operation, damage display quality/components of LCD module
and/or shorten the module's life.
4. Connect one end of the power cord to the AC inlet on the back of the monitor and the other end to the power outlet.
NOTE:
Please refer to Caution section of this manual for proper selection of AC power cord.
5. Turn on the monitor with the front power button (Figure E.1) and the computer.
6. No-touch auto adjust automatically adjusts the monitor to optimal settings upon initial setup for most timings. For further
adjustments, use the following OSD controls:
• Auto Contrast (Analog input only)
• Auto Adjust (Analog input only)
Refer to the Controls section of this User's Manual for a full description of these OSD controls.
NOTE:
If you have any problems, please refer to the Troubleshooting section of this User's Manual.
Power cord
Figure C.1
Macintosh Cable
Figure A.2
Adapter
(not included)
Input (VGA)
Input (DVI)
Power indicator
English-7
Stand
Stand neck
Stand Base
Figure 1
DisplayPort cable
Figure A.3
Figure E.1
Larger side of
the stand base
faces front
Figure A.4
Power Button
- Quick Links:
- Controls
Hide quick links:
Advertisement
Table of Contents
