Toro 22321G Setup Instructions
Compact utility loader
Hide thumbs
Also See for 22321G:
- Operator's manual (52 pages) ,
- Quick start quide (2 pages) ,
- Operator's manual (48 pages)
Advertisement
Quick Links
TX 427 Compact Utility Loader
Model No. 22321—Serial No. 280000001 and Up
Model No. 22321G—Serial No. 280000001 and Up
Model No. 22322—Serial No. 290000001 and Up
Charging the Battery
Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
1. Open the rear access cover.
2. Connect a charger to the battery (Figure 1) and
charge it for a minimum of 1 hour at 6 to 10 amps.
Do not overcharge the battery.
4
2
Figure 1
1. Positive post
2. Negative post
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks
and flames away from battery.
© 2008—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
3
1
G003792
3. Charger red (+) wire
4. Charger black (—) wire
Register at www.Toro.com.
3. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the
charger leads from the battery posts (Figure 1).
4. Close the rear access cover.
Checking Fluid Levels
Before starting the engine for the first time, check
the engine oil and hydraulic fluid levels. Refer to the
Operator's Manual for more information.
Setting the Engine RPM (CE
Only)
If you are setting up this machine for use in the
European Community, you need to permanently adjust
the engine speed so that it does not run above 3300
RPM, as follows:
1. Start the engine and run it at half throttle for 5 to
10 minutes to warm it up.
Important: The engine must be warm before
making this adjustment.
2. Move the throttle lever to the Fast position.
3. Check the engine speed on the tachometer.
It should be around 3600 RPM.
4. Loosen the jam nut securing the high idle adjusting
screw on the engine (located on the throttle/choke
control linkage—Figure 2).
Form No. 3360-711 Rev A
Setup Instructions
Original Instructions (EN)
Printed in the USA
All Rights Reserved
Advertisement
Related Manuals for Toro 22321G
Summary of Contents for Toro 22321G
- Page 1 Form No. 3360-711 Rev A TX 427 Compact Utility Loader Model No. 22321—Serial No. 280000001 and Up Model No. 22321G—Serial No. 280000001 and Up Model No. 22322—Serial No. 290000001 and Up Setup Instructions Charging the Battery 3. When the battery is fully charged, unplug the charger from the electrical outlet, then disconnect the charger leads from the battery posts (Figure 1).
- Page 2 G009175 Figure 3 G009157 Figure 2 1. Hood latch handle 3. Bolt and washer 2. Slotted hood latch 1. High idle adjusting screw 3. Throttle/choke control linkage 2. Jam nut 4. Remove and discard the hood latch handle. 5. Insert the slotted hood latch into the opening and 5.