Table of Contents
Advertisement
Multiple monitors connection using DisplayPort
You can daisy-chain monitors to each other using the DisplayPort OUT/IN connections on the monitors.
For using connected monitors in MST (multi-stream transport) mode, the setting should be DP OUT MULTISTREAM "AUTO" for
each monitor. Please change the setting for the monitor that connects to the computer last.
If the monitors do not display an image, turn off the monitor connected to the computer then turn it back on.
Configuring the DisplayPort connections may be necessary. Please refer to the table below and change the settings as needed.
OSD (See
page
18)
DP OUT MULTISTREAM "CLONE"
DP OUT MULTISTREAM "AUTO"
Depending on the display adapter settings in the operating system for the connected computer, the image may not extend.
Please refer to the user instructions for the computer to change the settings.
NOTE:
Use the DisplayPort cables included with the monitors to connect the monitors to each other.
We strongly recommend using the same monitor model for all monitors in the connected daisy-chain.
Remove the cap from the DisplayPort OUT connector on the monitor.
Please contact your display adapter supplier for detailed information.
MST (multi-stream transport)
The number of monitors that can daisy-chain, from a single connection to the computer, depends on the display
NOTE:
adapter capabilities and its settings.
Please refer to the user instructions for the computer or display adapter.
DisplayPort
DisplayPort cable
NOTE:
When the monitor has no image, follow the troubleshooting step Recovering from no image and select
DP VER "1.1" (below).
When set the MST function is selected, the power management function according to the ErP directive doesn't work.
Recovering from no image
If the monitors do not display an image after configuring DP OUT MULTISTREAM, please follow the instructions below:
1. Turn off the computer.
2. Touch the "MENU" key to show the No Signal OSD menu.
3. Touch the " " key to show the VIDEO INPUT menu.
4. Touch " " or " " to show the DisplayPort switch menu.
5. Select DP VER "1.1" to switch the DisplayPort setting.
6. Touch MENU to close the OSD menu.
7. Turn on the computer.
MST (multi-stream transport) and SST (single-stream transport) requires a corresponding display adapter.
NOTE:
Check to make sure that the display adapter supports MST (multi-stream transport).
Please refer to the user instructions for the computer to change the settings.
NOTE:
Use the DisplayPort cables included with the monitors to connect the monitors to each other.
Factory setting.
DisplayPort 1.1a setting with:
– SST (single-stream transport).
DisplayPort 1.2 setting with:
– SST (single-stream transport) and MST (multi-stream transport).
BIT RATE
Maximum number of connectable monitors
HBR2 (Default setting)
2 units (HDCP contents: 2 units)
HBR
1 unit (HDCP contents: 1 unit)
DisplayPort OUT
DisplayPort IN
DisplayPort IN/OUT
DisplayPort cable
English-13
DisplayPort IN/OUT
DisplayPort cable
Advertisement
Table of Contents
