Table of Contents
Advertisement
Sticking the Installation Guide Map and Fixing Indoor Unit
1) Put an Installation Guide Map on the desired
surface.
INSTALLATION GUIDE MAP
2) Look at suited horizon by horizontal meter on
the horizontal setting line, and fix lightly the
map by adhesive tape.
I N
S T
A L
L A
Horizontal meter
3) Make a hole with diameter of 6mm and depth of
I N
S T
A I
I A T
4) Drill the piercing part for connecting pipe as
diameter 50mm. (In case of piercing rear surface)
5) Drive the plastic anchors into drilled points.
Plastic anchors
6) First, drive the two points of the upper parts by
screws. (Leave 10mm for hanging product)
I N
S T
A L
T I O
N
G U
I D
E M
A P
I O
N
G U
I D
E M
A P
I N
S T
A L
L A
T I O
N
G U
I D
E M
A P
L A
T I O
N
G U
7) Hang the hole of product at the upper screws.
(In this time, remove the map)
(Falling attention)
Hanger hole
(Rear side of
product)
8) Drive the lower parts after facing the hole of
product with plastic anchors, and fix completely
the upper screws.
9) Check the fixed product with light power.
10) Drive the lower parts after facing the hole of
product with plastic anchors, and fix completely
the upper screws.
Installation
I N S
T A L
L A T
I O N
G U I
D E
M A P
Plastic anchors
Installation Manual 9
Advertisement
Table of Contents
