Related Manuals for Toro 30104
Summary of Contents for Toro 30104
- Page 1 Form No. 3425-683 Rev A 3bu. Soft Bag 36in and Larger Fixed and Floating Deck Walk-Behind Mower Model No. 30104 *3425-683* A Register at www.Toro.com. Original Instructions (EN)
-
Page 2: Table Of Contents
Debris, such as leaves, grass, or brush can additional information, contact an Authorized Service catch fire. A fire in the engine area can cause Dealer or Toro Customer Service and have the model personal injury and property damage. and serial numbers of your product ready. -
Page 3: Safety And Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal114-3489 114-3489 1. Thrown object hazard; cutting/dismemberment hazard—do not operate the machine with the discharge opening uncovered;... -
Page 4: Setup
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. Back plate Support Mounting bracket Bolt (1/4 x 5/8 inch) Locknut (1/4 inch) Assemble the bagger. Left latch Right latch Phillips head screw (#10) Locknut (#10) Lock washer (#10) Bag and pan... -
Page 5: Assembling The Bagger
Install the latches to both sides of the back plate using 4 phillips-head screws, lock washers, and locknuts (#10) as shown in Figure Important: Do not completely tighten the Assembling the Bagger nuts; the latches should be able to move up and down. -
Page 6: Assembling The Bag And Frame
Push 2 bolts (1/4 x 1 inch) through each handle and the fabric from the outside, and secure them with 4 washers (1/4 inch), and locknuts (1/4 inch) as shown in Figure Assembling the Bag and Frame Parts needed for this procedure: Bag and pan Catcher frame Handle... -
Page 7: Installing The Bagger Onto The Mower
Place the rear hook over the mower mounting bracket (Figure Installing the Bagger onto the Mower Parts needed for this procedure: Bagger clamp Bolt (3/8 x 1 inch) Locknut (3/8 inch) Procedure g002160 WARNING Figure 6 An uncovered discharge opening could allow 1. - Page 8 If you are installing the bagger for the first time Lift the latches and slide the frame side pins into or moving it to a mower of a different size, install them (Figure or move the bagger clamp as follows: Lower the latches to secure the bagger.
-
Page 9: Operation
Emptying the Bagger Operation Disengage the PTO, bring the machine to neutral position and set the parking brake. WARNING Shut off the engine, remove the key, and wait To avoid personal injury, follow these for all moving parts to stop before leaving the procedures: operating position. -
Page 10: Operating Tips
Operating Tips Mower Width The mower is wider with the bagger installed. By turning too sharply in confined places you may damage the bagger. Mowing Side Mow with the left side towards objects such as trees or landscaping. Do not mow with the right side of the mower near objects because you could damage the bagger. -
Page 11: Maintenance
Maintenance WARNING You or bystanders could be severely injured by flying debris or thrown objects CAUTION that may pass through torn, worn, or If you leave the key in the ignition switch, deteriorated grass bags. someone could accidently start the engine and seriously injure you or other bystanders.