Installation - NEC MultiSync LCD1525V User Manual
Nec display solutions multisync monitor user's manual lcd1525v
Hide thumbs
Also See for MultiSync LCD1525V:
- Service manual (109 pages) ,
- User manual (36 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
Installation
Installation
To attach the MultiSync LCD
instructions:
1. Turn off the power to your computer.
2. For the PC: Connect the 15-pin mini D-SUB of the appropriate
signal cable to the connector of the display card in your system
(Figure A.1). Tighten all screws.
For the Mac: Connect the MultiSync LCD
adapter to the computer (Figure B.1). Attach the 15-pin mini
D-SUB end of the appropriate signal cable to the MultiSync
LCD
screws.
3. Remove connector cover and cable cover. Connect the 15-pin
mini D-SUB of the video signal cable to the appropriate connec-
tor on the back of the monitor (Figure C.1).
Place the Video Signal Cable under Clip A. Then place AC
Adapter Cable under Clip B.
Replace connector cover and cable cover.
NOTE: Incorrect cable connections may result in irregular operation,
damage display quality/components of LCD module and/or shorten the
module's life.
4. Connect one end of the power cord to the MultiSync LCD
Series monitor and the other end to the power outlet (Figure
D.1).
5. Turn on the monitor (Figure E.1) and the computer.
6. To complete the setup of your MultiSync LCD monitor, use the
following OSM controls:
• Auto Adjust Contrast
• Auto Adjust
Refer to the Controls section of this User's Manual for a full description
of these OSM controls.
NOTE: If you have any problems, please refer to the Troubleshooting
section of this User's Manual.
LCD1525E.PM5
1525V
Macintosh cable adapter (Figure B.1). Tighten all
1525V
Page 19
monitor to your system, follow these
Macintosh cable
1525V
99/06/09, 14:33
E - 7
PageMaker 5.0J
Advertisement
Table of Contents
