User Manual FYD00226WC CONTENTS Safety Information........2 Care and cleaning........8 Safety Instructions........4 What to do if..........9 Installation..........5 Technical Information....... 11 Usage............6...
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. Children and vulnerable people safety This appliance can be used by children aged from 8 years •...
Page 3
SAFETY INFORMATION Never remove or damage stickers, warning labels or • nameplates attached to the appliance. A qualified technician carrying out the installation is obliged • to observe applicable national standards and regulations concerning connection to the water distribution system and the electric network.
SAFETY INSTRUCTIONS set to turn ON or OFF the water heating Installation system only. • Obey the installation instruction supplied with the appliance. • Remove all the Packaging items. • Do not install or use a damaged appliance. • Before first time starting up, check the appliance for any damage incurred during transport.
INSTALLATION 4. Move water dispenser, align fixing Placement bracket hole with screw hole of the floor 5. Put the 25mm screw into the screw hole WARNING! of fixing bracket. Do not install the water dispenser in a 6. Tighten the screw. location where there is a direct impact of sunlight or near heat sources, as a stove, oven, etc...
USAGE 2. Switch on the cooling and/or heating WARNING! switches . The heating/cooling lamp will be ON, which Depending on the maker and model of indicates that the system is in the heating/ the water bottle, there may be some cooling process.
Page 7
USAGE When the machine is under the ice point and blocked by ice, the cooling switch must be closed for 4 hours before turning it on again to continue its operation. The appliance should not be turn on until 3 minutes later after turning off the power switch.
CARE AND CLEANING The machine had been disinfected before water through the two buttons (run out departed from the factory. all the water). 7. Fill 1/3 of the bottle with clean water. Never clean your water cooler with Replace the bottle and remove all the flammable fluids such as alcohol, kerosene, water by triggers and drainage cap.
WHAT TO DO IF Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling the service technicians, before contacting the service centre please carry out the check listed below. PROBLEM POSSIBLE CAUSE(S) SOLUTION Electric plug out of the Plug in.
Page 10
WHAT TO DO IF PROBLEM POSSIBLE CAUSE(S) SOLUTION Electric plug out of the Plug in. Water not hot socket. from hot tank Hot water switch is not on Switch on the hot water switch...
TECHNICAL INFORMATION Model FYD00226WC Voltage (V) 220-240 AC Frequency (Hz) 50/60 Rating power (W) Rating current (A) Rating power (W) Rating current (A) Chilled water temperature (°C) ≤10 Cooling Chilled water capacity min at 32° C ambient (L/hr) Water tank volume (litre) Chilled water flow rate (L/Min) ≥1.2...
Page 12
TECHNICAL INFORMATION Heating lamp Hot water power switch Power lamp Cold water power switch Hole punch for water bottle Child Lock Hot water button Cold water button Hot water tap Cold water tap Water collector grid Cooling lamp...
Page 13
ENVIRONMENTAL CONCERNS dispose appliances marked with the symbol Recycle the materials with the symbol with the household waste. Return the Put the packaging in applicable containers product to your local recycling facility or to recycle it. Help protect the environment contact your municipal office.