Operation Setting - Ventilator; Operation Mode; Temperature Setting; Controlling Desired Temperature - LG PREMTB100 Owners & Installation Manual
Wired remote controller
Hide thumbs
Also See for PREMTB100:
- Owners & installation manual (72 pages) ,
- Engineering product data book (48 pages)
Table of Contents
Advertisement
OPERATION SETTING - VENTILATOR
20
OPERATION SETTING - VENTILATOR
Operation mode
Ventilation (general and direct cooling type ventilation) operation mode supports the following op-
eration modes.
※Some products may not support some operation modes.
Mode
Classification
It measures the ventilation system's indoor tempera-
Auto
ture and the outdoor temperature for the automatic op-
eration in the optimal ventilation mode state.
It is the mode of ventilation with both supply/discharge
Ventilation operation
through the heat exchanger. It is adequate to use in
Heat Exchange
mode – commonly
summer/winter where the indoor/outdoor temperature
supported by ventila-
difference is big.
tion products
It is the ventilation where the exhausted air is ventilated
without going through the exchanger. It is adequate to
Bypass
use in spring/fall or when the indoor contamination is
severe.
Cool
Cools down the room to desired temperature.
Heat
It provides warm air to the room.
Air conditioner opera-
tion mode – supports
The product automatically provides the appropriate fan
direct cooling type
Auto
speed based on the temperature of the room.
ventilation
Stop
It stops the product's air conditioner operation.
In the main screen, press [<,>(left/right)] button to select the operation mode category, and press
[∧,∨(up/down)] button to set the operation mode.
※The direct cooling type ventilation's air conditioner operation mode is composed separately
from the ventilation operation mode.
Description
TEMPERATURE SETTING
Controlling Desired Temperature
You can easily control to the desired temperature.
• In the main screen, press [<,>(left/right)] button to select the desired temperature category,
and press [∧,∨(up/down)] button to set the desired temperature.
- In the cooling, heating, and AI/auto mode, the desired temperature control is possible.
Mode
If the desired temperature is higher than the indoor temperature, the
cooling is not performed.
Cool
Set the desired temperature lower than the indoor temperature.
You can select in the range of 18°C ~ 30°C (16°C ~ 30°C).
If the desired temperature is lower than the indoor temperature, the heat-
ing is not performed.
Heat
Set the desired temperature higher than the indoor temperature.
You can select in the range of 16°C ~ 30°C.
For cooling/heating product, you can select in the range of 18°C ~ 30°C.
AI / Auto
For cooling exclusive product, you can select Hot, A little hot, Adequate,
A little Cold, and Cold.
NOTE
!
The favorable temperature difference between the indoor temperature and the outdoor
temperature is 5°C.
TEMPERATURE SETTING
21
Description
Advertisement
Table of Contents
