Download
Share
Print this page
Brother NC-8100h Quick Network Setup Manual
  1. Manuals
  2. Brands
  3. Brother Manuals
  4. Server
  5. NC-8100h
  6. Quick network setup manual
Brother NC-8100h Quick Network Setup Manual

Brother NC-8100h Quick Network Setup Manual

Print/fax server
Hide thumbs Also See for NC-8100h:
1
2
3
4
5
6

Advertisement

Quick Links

Download this manual See also: User Manual
Quick Network Setup Guide
Caution: DO NOT touch the surface of the main boards within 15 minutes after turning off the power.
For more details about how to optimize the Network board, please refer to the Network User's Guide on the CD-
ROM supplied with the MFC.
Two Screws
Before Starting Installation:
Be careful when handling the NC-8100h. There are many delicate electronic components that are susceptible to
damage from static electricity. To avoid such damage, use the following precautions when handling the board:
•
Leave the NC-8100h in its anti-static bag until you are ready to install it.
•
Make sure that you are adequately grounded before touching the NC-8100h. Use an anti-static wrist strap and a
grounding mat if possible. If you do not have an anti-static wrist strap, touch the bare metal surface on the back
of the machine before handling the NC-8100h.
•
Avoid moving around the work area in order to eliminate static charge build-up.
•
If possible, do not work on a carpeted area.
•
Do not flex the board and do not touch the components on the card.
Tools Required:
Phillips Screwdriver
NC-8100h
Quick Network Setup Guide
Print/Fax Server
1
One Touch Key Sheet
(For use with MFC9660, MFC9880,
MFC9800 Only)

Advertisement

loading

Related Manuals for Brother NC-8100h

Summary of Contents for Brother NC-8100h

  • Page 1 • Make sure that you are adequately grounded before touching the NC-8100h. Use an anti-static wrist strap and a grounding mat if possible. If you do not have an anti-static wrist strap, touch the bare metal surface on the back of the machine before handling the NC-8100h.

  • Page 2: Step 1: Hardware Installation

    (e.g. Parallel Interface Cable) Unplug the phone lines from the side of the machine. Caution: Make sure the power cord is unplugged before installing or removing the NC-8100h Board. Open the manual feed cover at the rear of the machine.
  • Page 3 Remove the two screws securing the metal plate over the main board and remove the cover. Open the scanner cover by pulling the release lever towards you to make it easier to install the NC-8100h. Remove the protective label from the chassis.
  • Page 4 10. Plug the NC-8100h into connector P1 located on the main board as shown in the illustration. Make sure that both connectors are firmly together by pushing down the back of the NC-8100h. 11. Fit the two screws into the NC-8100h plate.

  • Page 5: Step 3: Installing The Bradmin Professional: Configuration Utility

    Pair 10Base-T or 100Base-TX Ethernet Network To connect the NC-8100h to a 10Base-T or 100Base-TX Network, you must have an Unshielded Twist Pair Cable. One side of the cable must be connected to a free port on your Ethernet hub and the other side must be connected to the 10Base-T or 100Base-TX connector (an RJ45 Connector) of the NC-8100h.

  • Page 6: Troubleshooting

    Check to see if there is any LED activity. The NC-8100h has a two color LED for diagnosing problems. • Orange LED: This LED will flash Orange when connected to a 100Base-TX Network and is receiving data.