Advertisement
Quick Links
Brush Guard Kit
Workman
Model No. 07145
Important:
You cannot use or install the Ball Cage Kit (Model No. 07161) with this kit.
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
No parts required
Long mount-bracket assembly
Nut (5/16 inch)
Brush guard
Carriage bolt
Bolt (5/16 x 3/4 inch)
Short upper brush-guard bracket
Carriage bolt (5/16 x 7/8 inch)
Nut (5/16 inch)
Brush guard
Lower brush-guard bracket
Bolt (5/16 x 3/4 inch)
Bolt (3/8 x 1 inch)
Nut (3/8 inch)
Preparing the Machine
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Shut off the engine and remove the key.
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
GTX or MDX Series Utility Vehicles
Qty.
–
1
8
1
2
4
1
2
8
1
1
4
4
4
Figure 1
Register at www.Toro.com.
Prepare the machine.
Install the brush guard (for GTX models).
Install the brush guard (for MDX models).
Original Instructions (EN)
All Rights Reserved *3437-482* A
Printed in the USA
Form No. 3437-482 Rev A
Installation Instructions
Use
g038447
Advertisement
Related Manuals for Toro 07145
Summary of Contents for Toro 07145
- Page 1 Form No. 3437-482 Rev A Brush Guard Kit Workman ® GTX or MDX Series Utility Vehicles Model No. 07145 Installation Instructions Important: You cannot use or install the Ball Cage Kit (Model No. 07161) with this kit. Installation Loose Parts Use the chart below to verify that all parts have been shipped.
- Page 2 Installing the Brush Guard Secure the brush guard to the bumper-mount bracket using 4 bolts (5/16 x 3/4 inch) and 4 nuts (5/16 inch) as shown in Figure 4 Figure For GTX Models Note: Install all fasteners loosely. Install the long mount-bracket assembly through the bumper (Figure g033820...
- Page 3 Installing the Brush Guard Install the lower brush-guard bracket to the bumper-support bracket using 4 bolts (3/8 x 1 inch) and 4 nuts (3/8 inch) as shown in Figure 8 For MDX Models Figure Note: Install all fasteners loosely. Install the short upper brush-guard bracket through the bumper (Figure g033822...
- Page 4 Install the brush guard to the short upper brush-guard bracket using 2 carriage bolts and 2 nuts (5/16 inch) as shown in Figure g033819 Figure 10 1. Carriage bolt 4. Carriage bolt 2. Short upper brush-guard 5. Nut (5/16 inch) bracket 3.