Table of Contents
Advertisement
14
Desired airflow direction
memory function
(Up/down louver only)
You can register a discharge angle in the prod-
uct by turning off the Auto Swing function at
the desired angle.
For setting desired airflow direc-
tion memory function
Press the Mode button and Temp. down but-
ton on the indoor unit simultaneously for 3
seconds. to register the discharge angle.
For releasing desired airflow
direction memory function
- Switch from the mode in which the Auto
Swing angle was registered to another mode
to clear the registered angle.
- Change the vane angle by setting another
function, such as Power Cooling Operation,
to clear the registered angle.
MODE
Auto restart operation
When power is supplied again after unit oper-
ation has been stopped because of interrup-
tion of power supply due to outage or other
causes, auto restart will be performed by
remembering previous setting.
- When power is supplied, outdoor unit opera-
tion will be started within 3 minutes.
1
Auto restart operation can be
established/released by manipulating
indoor unit button.
* When initial state, Auto restart operation
will be set up as standard.
For releasing restart function
Press the on/off, fan speed, high temp and
low temp buttons (4 buttons) simultaneously
for 3 seconds.
The unit will respond with beep and restart
operation will be removed.
For setting restart function
After funtion release, Press the on/off, fan
speed, high temp and low temp buttons (4
buttons) simultaneously for 3 seconds.
The unit will respond with beep and restart
operation will be setted.
MODE
Hide quick links:
Advertisement
Table of Contents
