Operating Instruction; How To Insert The Batteries; Wireless Remote Controller Maintenance; Operating Method - LG PQWRCQ0FDB Owners & Installation Manual
Hide thumbs
Also See for PQWRCQ0FDB:
- Owners & installation manual (50 pages) ,
- Owner's manual (266 pages)
Table of Contents
Advertisement
Operating Instruction
Operating Instruction
How to insert the Batteries
1. Remove the battery cover by pulling it according to the arrow
direction.
2. Insert new batteries making sure that the (+) and (-) of battery are
installed correctly.
3. Reattach the cover by sliding it back into position.
1. Always use/replace both batteries of same type.
2. If the system is not to be used for a long time, remove the
batteries to save their working life.
3. If the display screen of remote controller starts, fading replace
both of the batteries.
Wireless Remote Controller Maintenance
1. Choose a suitable place where its safe & easy
to reach.
2. Fix the holder to wall etc with the supplied
screws firmly.
3. Slide the remote controller inside the holder.
1. Remote controller should never be exposed to
direct sunlight.
2. Signal transmitter & receiver should always be
clean for proper communication. Use a soft
cloth to clean them.
3. In case some other appliances also get
operated with remote control, change their
position or consult your serviceman.
Operating Method
1. The signal receiver is inside the unit.
2. Aim the remote controller towards the unit to operate it.
There should not be any blockage in between.
6
Wireless Remote Controller
Installation Instructions
Installer Setting - Setting Address of Central Control
1
With the MODE button pressed, press the RESET button.
2
By using the TEMPERATURE SETTING button, set the indoor unit address.
- Setting range : 00 ~ FF
3
After setting the address, press the ON/OFF button toward the
indoor unit 1 time.
°C/°F(5 s)
TIME(3 s)
4
The indoor unit will display the set address to complete the address setting.
- The address display time and method can differ by the indoor uint type.
5
Reset the remote controller to use the general operation mode.
Installer Setting - Checking Address of Central Control
1
When FUNCTION button pressed, press RESET button
2
Press the ON/OFF button toward the indoor unit 1 time, and the indoor unit will display the set
address in the display window.
- The address display time and method can differ by the indoor unit type.
3
Reset the remote controller to use the general operation mode.
Installation Instructions
Group No.
Indoor Unit No.
Owner's & Installation Manual 7
- Quick Links:
- Wireless Remote Controller
Hide quick links:
Advertisement
Table of Contents
