Building Networks for Peopl e Quick Installation Guide 802.11n Unified Access Point This document will guide you through the basic installation process for your new D-Link 802.11n Unified Access Point. DWL-3600AP Quick Installation Guide Documentation also available on CD and via the D-Link Website...
LAN Port (PoE) Power Receptor Console Port NOTE no PSU supplied. To power the units (*Note no longer use an D-Link PoE switch or the D-Link Reset Port used, replaced DPE-101GI PoE injector. by PoE) *The console cable is an optional accessory and Figure 2.
Wall Installation Recommendations If you plan to install the DWL-3600AP on a wall or other vertical surfaces, orient the top of the access point (the side with the LEDs) toward the intended coverage area.
Page 4
Close text on the mounting ring. 7. Plug the CAT 5 cable into the LAN port on the access point. Figure 5. Plug cable into access point 4 D-Link DWL-3600AP Quick Install Guide...
Page 5
Ceiling crossbar Ceiling bracket 2. Use the provided screws to attach the mounting ring to the ceiling bracket. 4. Plug the CAT 5 cable into the LAN port on the access point. D-Link DWL-3600AP Quick Install Guide 5...
This device and it's antennas(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with IC multi-transmitter product procedures. Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnement en association avec une autre antenne ou transmetteur. 6 D-Link DWL-3600AP Quick Install Guide...
Page 7
Network Standby mode within 1 minute of no packets being transmitted. If it is not needed during certain periods of time, it can be unplugged to save energy. Network Standby: 6.4 watts D-Link DWL-3600AP Quick Install Guide 7...