Table of Contents
Advertisement
Maintenance
Toro has designed this product to give you years of
trouble-free use. Should the machine need service, take it to
an Authorized Toro Service Dealer.
WARNING
When the machine is connected to a household
power source, the machine is operational. Someone
could accidentally start the machine and cause a
serious injury to you or other bystanders.
Always disconnect the machine from the power
source whenever you leave the machine unattended.
Double-Insulated Appliances
In a double-insulated appliance, 2 systems of insulation are
provided instead of grounding. No means for grounding
is provided on a double-insulated appliance, nor should a
means for grounding be added to the appliance. Servicing
a double-insulated appliance requires extreme care and
knowledge of the system and should be done only by qualified
service personnel at an Authorized Toro Service Dealer.
Replacement parts for a double-insulated appliance must be
identical to the parts that they replace. A double-insulated
appliance is marked with the words "Double Insulation" or
"Double Insulated." The symbol (square within a square)
may also be marked on the appliance.
Cleaning the Machine Housing
After each use, clean the machine housing.
Before cleaning, stop the motor, wait for all moving parts to
stop, and disconnect the machine from the power source.
Important: Do not clean the machine with water.
Moisture can get trapped in the machine and may cause
corrosion of internal parts.
•
Clean the underside of the machine housing. Remove dirt
and grass clippings with a hardwood scraper or brush
(Figure
17).
g0151 16
•
Remove the debris from the housing vents along the top
of the machine.
•
Brush all the debris off the machine housing.
•
Inspect the power plug receptacle for signs of melting
or heating. Old, worn-out extension cord plugs that fit
loosely in the plug receptacle can cause overheating from
poor contact. Replace any damaged extension cords
immediately (if applicable).
Lubricating the Machine
Lubricate the wheels, linkages, and pivot points every 25
operating hours with engine oil
g0151 15
9
Figure 17
(Figure
18).
Figure 18
Advertisement
Table of Contents
