Network Mini Dome Camera·Quick Operation Guide Thank you for purchasing our product. If there are any questions, or requests, please do not hesitate to contact the dealer. About This Document This manual applies to the following models. Model This manual may contain several technical incorrect places or printing errors, and the content is subject to change without notice.
Network Mini Dome Camera·Quick Operation Guide FCC Information FCC compliance: This equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
Page 4
Network Mini Dome Camera·Quick Operation Guide municipal waste in the European Union. For proper recycling, return this product to your local supplier upon the purchase of equivalent new equipment, or dispose of it at designated collection points. For more information see: www.recyclethis.info. 2006/66/EC (battery directive): This product contains a battery that cannot be disposed of as unsorted municipal waste in the European Union.
Network Mini Dome Camera·Quick Operation Guide Safety Instruction These instructions are intended to ensure that user can use the product correctly to avoid danger or property loss. The precaution measure is divided into “Warnings” and “Cautions” Warnings: Serious injury or death may occur if any of the warnings are neglected.
Page 6
Network Mini Dome Camera·Quick Operation Guide ● Do not connect several devices to one power adapter as adapter overload may cause over-heating or a fire hazard. ● Please make sure that the plug is firmly connected to the power socket. When the product is mounted on wall or ceiling, the device shall be firmly fixed.
Page 7
Network Mini Dome Camera·Quick Operation Guide ● Do not place the camera in extremely hot, cold (the operating temperature shall be-30℃~+60℃,or -40°C ~ 60°C if the camera model has an “H” in its suffix), dusty or damp locations, and do not expose it to high electromagnetic radiation.
Network Mini Dome Camera·Quick Operation Guide 1 Appearance Description Figure 1-1 Overview (1) Figure 1-2 Overview (2)
Page 10
Network Mini Dome Camera·Quick Operation Guide Table 1-1 Physical Description Description Front Cover Dome Drive Micro SD Card Slot Network Cable Lens IR LED Power Cable Audio/Alarm Cables Wi-Fi Antenna Serial Port Interface Hex Screw RESET/WPS Button Press RESET about 10s when the camera is powering on or rebooting to restore the default settings, including the user name, password, IP address, port No., etc.
Page 11
Network Mini Dome Camera·Quick Operation Guide No.8 is the audio/alarm cable interface, of which the “I” mark connects to the alarm input, the “o” mark connects to the alarm output, the “GND” mark connects the grounding, and the “A” mark connects the audio output. ...
Network Mini Dome Camera·Quick Operation Guide 2 Installation Before you start: Make sure the device in the package is in good condition and all the assembly parts are included. Make sure all the related equipment is power-off during the ...
Network Mini Dome Camera·Quick Operation Guide ● Make sure that there is no reflective surface too close to the camera lens. The IR light from the camera may reflect back into the lens causing reflection. ● The foam ring around the lens must be seated flush against the inner surface of the bubble to isolate the lens from the IR LEDS.
Page 14
Network Mini Dome Camera·Quick Operation Guide A different type of drill template might be provided because of the different batches of products. And also, the contained adapter plate matches with type II drill template differs as well. See figure below. Drill Template Hole A :for cables routed through the wall Screw hole1 :for Mounting Base...
Page 15
Network Mini Dome Camera·Quick Operation Guide 3. Fix the adapter plate to the ceiling with the supplied expansion screws. Adapter Plate Side Outlet Figure 2-4 Fix the Adapter Plate If the supplied drill template is type II drill template, you can just skip step 3 and go straight to step 4.
Page 16
Network Mini Dome Camera·Quick Operation Guide 5. Connect the power cable, network cable, and the audio/alarm cables. Use a plier to remove the removable part and route the cables via side outlet (as shown in Figure 2-4) if no cable hole is drilled in step 1, and connect the corresponding cables.
Page 17
Network Mini Dome Camera·Quick Operation Guide Adjusting Tool Rotation Tilt Figure 2-7 3-Axis Adjustment 9. Tighten the hex screw to fix the well-adjusted surveillance angle. 10. Align the front cover to the dome drive and tighten the set screws on the front cover. Figure 2-8 Install the Front Cover...
Network Mini Dome Camera·Quick Operation Guide 11. Tear off the protection film softly to complete the installation. Do not tear off the protection film until the installation is completed. Do not touch the inside face of the bubble with your hands. ...
Page 19
Network Mini Dome Camera·Quick Operation Guide Figure 2-10 Fix the Dome Drive 3. Connect the power cable, network cable, and the alarm/audio cables. 4. Align the front cover to the dome drive and tighten the set screws on the front cover. Figure 2-11 Install the Front Cover...
Network Mini Dome Camera·Quick Operation Guide 5. Tear off the protection film softly to complete the installation. Do not tear off the protection film until the installation is completed. Do not touch the inside face of the bubble with your hands. ...
Page 21
Network Mini Dome Camera·Quick Operation Guide Figure 2-12 Fix the Adapter Plate 3. Install the dome drive to the adapter plate. Figure 2-13 Fix the Dome Drive...
Network Mini Dome Camera·Quick Operation Guide 4. Align the front cover to the dome drive and tighten the set screws on the front cover to complete the installation. Figure 2-14 Install the Front Cover 5. Tear off the protection film softly to complete the installation. Do not tear off the protection film until the installation is ...
Page 23
Network Mini Dome Camera·Quick Operation Guide 1. Install the wall bracket to the wall with the supplied screws in the wall bracket package. The matched ceiling bracket model is DS-1272ZJ-120B, and you need to purchases it separately if wall bracket mounting is adopted. Figure 2-15 Install Wall Bracket 2.
Page 24
Network Mini Dome Camera·Quick Operation Guide 3. Fix the dome drive to the wall bracket with the supplied screws. Figure 2-17 Install the Camera 4. Align the front cover to the dome drive and tighten the set screws on the front cover to complete the installation. Figure 2-18 Install the Front Cover 5.
Network Mini Dome Camera·Quick Operation Guide Do not touch the inside face of the bubble with your hands. 2.5 Install the Micro SD Card This series of camera supports local storage, please refer to the following steps to install the micro SD card. Steps: 1.
Page 26
Network Mini Dome Camera·Quick Operation Guide Mirco SD Card Figure 2-20 Install and Uninstall Micro SD Card...
Network Mini Dome Camera·Quick Operation Guide 3 Setting the Network Camera over the Purpose: To view and configure the camera via LAN (Local Area Network), you need to connect the network camera in the same subnet with your PC. Then, install the SADP or PCNVR software to search and change the IP of network camera.
Page 28
Network Mini Dome Camera·Quick Operation Guide Refer to the following introductions to set IP address with the Advidia Camera Finder Utility software (for more detailed instructions please download the Camera Finder manual from the Advidia Website www.advidia.com/support): After launching the Advidia Camera Finder software, it automatically searches the online devices from the subnet where your computer is located.
Network Mini Dome Camera·Quick Operation Guide Click the refresh icon to refresh the online device list manually. The newly discovered devices will be added to the list. Note: You can click on each column heading to order the information. Modify device information Steps: Select the device(s) to be modified in the device list as shown in Figure 3-3.
Page 30
Network Mini Dome Camera·Quick Operation Guide Login Manager Figure 3-4 Launch Edit Table Figure 3-5...
Page 31
Network Mini Dome Camera·Quick Operation Guide Edit Table Figure 3-6 5) Enter the desired IP address (or range if changing the IP address of more than one device) of the network camera in the address field of the edit table and click Apply Network Changes. You can also select “Dynamic IP”...
Network Mini Dome Camera·Quick Operation Guide 4 Accessing via Web Browser System Requirement: Operating System: Microsoft Windows XP SP1 and above version / Vista / Win7 / Server 2003 / Server 2008 32bits CPU: Intel Pentium IV 3.0 GHz or higher RAM: 1G or higher Display: 1024×768 resolution or higher Web Browser: Internet Explorer 6.0 and above version, Apple Safari...
Page 33
Network Mini Dome Camera·Quick Operation Guide Login Interface Figure 4-1 5) Install the plug-in before viewing the live video and managing the camera. Please follow the installation prompts to install the plug-in. Note: You may have to close the web browser to finish the installation of the plug-in.
Page 34
Network Mini Dome Camera·Quick Operation Guide Download Plug-in Figure 4-2 Install Plug-in Figure 4-3...
Page 35
Network Mini Dome Camera·Quick Operation Guide Install Plug-in Figure 4-4 6) Reopen the web browser after the installation of the plug-in and repeat the above steps 2-4 to login. Note: For detailed instructions of further configuration, please refer to the camera’s user manual...